-
-
JJeremy-WI replied to the thread Starter Cable.I just replaced the starter on my 2006 last year and also replaced the front driveshaft because the rear boot was shot. Rockauto had an...
-
JJeremy-WI replied to the thread Rear Swing-Gate Flip-Glass Alignment.Is the hinge pin getting wore out on one side?
-
JJeremy-WI replied to the thread Seized upper control arm bolt. Attempt to remove it myself, or admit defeat and take it to a garage?.A sawzall will work but you will be bloody. The stroke on the sawzall I had was a bit long for the space on top of the blades being...
-
JJeremy-WI replied to the thread Driving without front drive shaft.I saw I slight improvement in gas mileage when my front driveshaft was out. from 20 mpg to about 22 mpg. I removed it to replace the...
-
JJeremy-WI replied to the thread What did you do to your jeep today?.Oil pressure switch connected well to the wiring harness?
-
JJeremy-WI replied to the thread Mystery P0300 root cause?.No braking then, the automatic braking only happens while using cruise
-
JJeremy-WI replied to the thread Mystery P0300 root cause?.I haven't hooked up a scantool to see what it may report but I am sure that it just shifts the trans into third gear with the TCC locked...
-
JJeremy-WI replied to the thread Mystery P0300 root cause?.I think the deceleration mode only works going downhill using cruise control on my 2006 and then it happens when the speed is about 5...
-
JJeremy-WI replied to the thread 09 Won't Idle, No Codes.Must not be a position sensor on the EGR to report it being open
-
JJeremy-WI replied to the thread O2 Fault Codes.You really want to see higher voltage on the O2's that are downstream of the catalytic converters as this shows that the excess fuel is...
-
-
Loading…
-
Loading…
