-
-
ikuo78 reacted to u2slow's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with
Like.
Bilsteins aren't worth paying extra for IMHO. Ours had them on the rear and I went to Monroe's after lifting. On my Dodge, Bilsteins... -
ikuo78 reacted to KJowner's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
H&R springs and some new shocks will freshen it up nicely.
-
Yesterday I pressure washed Giddyups underside to prevent as much dirt as possible from falling into my eyes as I dropped her fuel tank...
-
In order to finish off the in tank LP install, I drilled a hole in the unibody, behind the drivers seat and under the carpet, for the...
-
Wifey had major surgey and is recovering well, so finally had some time to work on Bert in between wound care and drain purges (gross...
-
ikuo78 replied to the thread Engine/Crankcase Breathers.I am trying to do this to lower the pressure inside the crankcase. The breather hose connected upstream of the throttle is basically...
-
It works but its very aggressive, wouldn't recommend it if other derust products are available, very glad I greased the bits I didn't...
-
All dry, still look rough but with the pitting that's not a surprise, the bores are still slightly greasy so hopefully the overspray...
-
ikuo78 replied to the thread What did you do to your jeep today?.I replaced the head cover gasket probably about two years ago. Recently the oil leak has recurred, so I'm attaching a tin can to a...
-
-
Added a 20" light bar, plus fixed the droopy tilt steering by drilling through the clamps and putting a bolt through them. I also...
-
ikuo78 replied to the thread Shock Recommendations.The rubber bushing can wear down to the point where a gap appears between the mounting eye's inner sleeve and the rubber bushing. When...
-
-
Started to clean up my spare clevises, I hammered the heavy rust off then had a brainwave... dip them, a quick Google search suggested...
-
picked up the running gear
-
Carrying on with the stripping of my parts Jeep. The strength difference between an 8.25 and a 30a is quite obvious when you look at them!
-
ikuo78 reacted to KJowner's post in the thread Will KK front end struts and spring work on a KJ? with Like.
Randomly surfing YouTube & came across this video. Guy is fitting KK struts onto his KJ so it looks like they fit straight on.
-
-
Loading…
-
Loading…
Staff online
-
GriffinNew Member