CheddarGau's latest activity
-
CCheddarGau replied to the thread 4.10 gear finally Installed.I opted for the P rated version to keep the weight down. C and E rated aren't necessary for my uses. I dont rock crawl to extra plies on...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.I've never looked into it. Some scan tools on older dodges (late 90's early 2000's) will allow you to change the tire size in the...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.These are Duratracs as well, so they have pretty big lugs
-
CCheddarGau replied to the thread 4.10 gear finally Installed.245/70r17
-
CCheddarGau replied to the thread 4.10 gear finally Installed.So a little update, I almost filled up (used points so not completely), and have some mileage number. Typical tank (fill to gas light)...
-
CThanks, great explanation! After I posted I thought wait a minute, transfer case wouldn’t allow the front and back to ‘connect’ in 2wd.
-
CCheddarGau replied to the thread 4.10 Re-gearing - 2025.In your case you are being overly cautious. Its better to be overly cautious in this case .
-
CCheddarGau replied to the thread 4.10 Re-gearing - 2025.Yes the gears are turning, but they are open diff and more importantly are disconnected from the transfer case. By leaving the t-case in...
-
CCheddarGau replied to the thread 4.10 Re-gearing - 2025.So the hardest part of doing gears in the gear pattern. Make your own set up bearings, which will allow you to slide it on the pionon...
-
CCheddarGau replied to the thread 3.7 engine swap into a Jeep Patriot.Thats a good call. The patriot platform isn't the best choice for much of anything. They aren't terrible, but its meant more as city...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.That's rough. I had a free day after work, so I stayed late and did it. I will work on the ground, but I'm spoiled and prefer not...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.You don't have to do it the way I did, but even paying for new front and rear gears, from a driveabilty stand point it's a very...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.Yeah buying it ahead of time, making sure its set up properly and slapping it in, is just easier. The front was always going to be set...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.Did it myself, I got close, I didn't have extra pinion bearings on hand to make a set up bearings. I had assumed we had the pinion depth...
-
CFinally got around to installing my 4.10 gears in the rear. Couple reasons for this. Upgraded to some larger tires a few months back...
