DadOSix's latest activity
-
DadOSix reacted to BubbaRand's post in the thread Some please help - how do I find responses with
Like.
thank you also! -
DadOSix replied to the thread right front intermediate shaft.Nice find! It is a few bucks more than the one I posted from the other link, but if shipping can be factored, it is pretty darn close.
-
I see the shaft on rockauto, part number 84270.
-
DadOSix replied to the thread Front suspension noise.Also - looks like you did not list lower control arm bushings. If all the above are new and torqued as @Gyro suggested, I’d be...
-
DadOSix replied to the thread Some please help - how do I find responses.You can also click on your avatar (user name and picture) and click on the number below Messages. It will take you to every thing you...
-
DadOSix replied to the thread Bunch of lights with the speedometer and RPM gauge not working.Imo - the answer to most of your issues lies here. These jeeps are notorious for wiring / ground issues. What are we looking at, where...
-
DadOSix replied to the thread right front intermediate shaft.- thinking about this - Did you actually pull the intermediate shaft out? Could be like mine - there is a lot of play (or slop) and...
-
DadOSix replied to the thread right front intermediate shaft.Tim - From a similar thread this past week...
-
DadOSix reacted to u2slow's post in the thread strange "rotational" noise like a bad u-joint with Like.
I drove the jeep on axle stands to isolate my drivetrain noise. (Thought it was the t-case). After trying both 2wd and 4wd with no...
-
DadOSix replied to the thread starter replacement in remote location.totally do-able in the field - if you have a way to get under the jeep. sounds worse than it is, to be sure.
-
DadOSix replied to the thread Shot intermediate shaft?.Thanks for that link! If there were still a true machinist here in town, I would just take it to the shop and have him either weld it...
-
DadOSix replied to the thread Shot intermediate shaft?.Yes. I hold em by the intermediate shaft and after spraying the splined area with FreeAll rust eater stuff, soak it a while then smack...
-
DadOSix replied to the thread Shot intermediate shaft?.Possibly. The seal surface looks decent. Concern is the shaft where the bearing runs is considerably worn from lack of lube. I will...
-
DadOSix replied to the thread Shot intermediate shaft?.- if it is dry, count on the shaft being damaged. There is a good parts diagram on Crown Automotive that shows the exploded view, but...
-
DadOSix replied to the thread Shot intermediate shaft?.I am doing this very thing, while replacing the right side ball joints. I have known the shaft seal was leaking, but it was a ‘get to...
Staff online
-
LibertyTCWell-Known Member