DadOSix's latest activity
-
DadOSix replied to the thread Power Steering Issue.If your pump is not leaking all over the jeep, you may be drawing air in the return line, or have a leaky rack and pinion. Hard to tell... -
DadOSix replied to the thread No crank no start anti theft light.Don’t forget to consider the ign switch actuator / broken pin scenario. In a nutshell - key on, lites on, no crank, but you can jump...
-
Agreed Brutha, but my main reason is just in case the cooler on the condenser isn’t serving its purpose, I wanna have peace of mind that...
-
DadOSix reacted to MsRandiCook's post in the thread Pulled the trigger OME via Rocky Road with
Like.
Here I go! -
DadOSix replied to the thread KK TRANSMISSION INLET AND OUTLET?.I did not think the direction of flow would matter. Is there a check valve involved somewhere? Also - I never had much faith in the...
-
DadOSix replied to the thread 3.7 2006 coil dropping out?.Wiring, internal damage, bad lifter (lash adjuster) Bad rocker. Based on your trace, I am going with wiring. These things are older...
-
DadOSix replied to the thread '12 KK transmission dipstick?.This works well. I used on my dodge caravan. Good find Lauren! Btw - if your scan tool does not do temp, you can shoot the pan with a...
-
DadOSix replied to the thread HOW TO: Change Transfer Case Position Switch.I was pressed for time when I did my last one, and did not have the o-ring seal. Found a close match in a kit of o-rings that I bought...
-
DadOSix replied to the thread 04 Liberty Brake Line.Sounds right to me!
-
I have an 02 Suburban for my own vehicle, luckily someone replaced brake lines all around right before I bought it, haha! But this job...
-
DadOSix replied to the thread 04 Liberty Brake Line.Yeah, I figured you got the pre-bent. Did that on my Silverado - and some are a real booger to get there. The line is not just copper...
-
The line I bought is prebent, specifically meant for a Liberty. I got them from SSTubes. Maybe getting a roll of copper line wouldve...
-
DadOSix replied to the thread 04 Liberty Brake Line.You may find it easier to work with NiCopp line. It is in a roll, double flares easily, and more easy to bend around and flex and mount...
-
DadOSix reacted to Patrick McGrinder's post in the thread Manifold Absolute Pressure Sensor Connector with Like.
Napa is where I got both pieces, thanks !
-
DadOSix replied to the thread I've spun bearings on every 3.7 I've owned...Yup!
