DadOSix's latest activity
-
DadOSix replied to the thread 2006 liberty limited automatic transmission failed.Just a guess, but I think you buy their ‘in the box’ reman and return yours for a core. Probably no way to tell on the replacement unit. -
DadOSix reacted to AntonioStitches's post in the thread Hard brake pedal and hard to stop with
Like.
Found the issue! lol I knocked off this line to the brake booster trying to get the rear bolt on for the upper control arm. Glad I found... -
DadOSix replied to the thread Belt tensioner >> stripped@@*.* << mounting bracket.I read both posts - not much experience from me on CRD jeeps, but … It *now* sounds like you stripped the bolt that holds the pulley to...
-
DadOSix replied to the thread Belt tensioner bolt stripped..
-
DadOSix replied to the thread HOW TO: Change Transfer Case Position Switch.There is nothing on the dash when you are in 2wd. The lamp shows when the transfer case is in other than 2wd. My 06 is a bit...
-
DadOSix replied to the thread Hard brake pedal and hard to stop.Caliper binding / or not re-installed correctly Pinched brake line / hose Brake line in the frame damaged when you were doing UCA’s (on...
-
DadOSix replied to the thread Reverse to drive dead zone..Check your transmission fluid level
-
Head gasket leak is a common problem of the 3.7 pass 100k, just resurface the head and get a new gasket. The most critical part is get a...
-
Probably a head gasket leak. Doesn’t have to be the end of the Jeep at all. Resurface the heads, install new gaskets, and keep driving it.
-
FIXED. Well, sort of. I located and removed the alarm unit with siren. Job done!!
-
FIXED. I located the siren alarm unit, and removed it. It's behind RH headlight.
-
DadOSix reacted to tyates007's post in the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? with Like.
Thank you!
-
DadOSix reacted to CheddarGau's post in the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? with Like.
Yeah the torque spec vs real world torque required to get the correct pre-load aren't the same haha. 24Turbo is correct, crank it down...
-
DadOSix reacted to 24turbo's post in the thread Front differential crush washer/pinion nut torque 500 ft/lbs?? with Like.
When I replace a seal I do it slightly different. I make a good quality scribe mark on the nut and yolk. When re-assembling I tighten...
-
DadOSix replied to the thread Did i get the wrong regulator.So - if it works a few times and then binds at the top, it may pop off again. Not a bad regulator, but now you know where and what to...
