ikuo78's latest activity
-
Out for a drive in the rain today doing some exploring. -
Hello peeps! After my engine swap my mechanic decided that he should overtighten the cap on my coolant overflow tank to a point where...
-
I haven't had any trouble with the CVs, but I did drop the cradle 3/4" to help things out.
-
It's not approved by jba, but you can mount the ball joint to the bottom of the uca which moves it away from the coil, but then you must...
-
Likely uca contacting the spring. I set mine up with a piece of paper as a feeler gauge between coil and uca adjusting at clevis. It's a...
-
There is … an SFA swap ;)
-
ikuo78 replied to the thread 3-5 inch lift.If you jack the car so that the suspension is extended, you can check the location of the collision. There may be individual...
-
ikuo78 replied to the thread Mystery P0300 root cause?.The easiest way to tell that the PCM is failing is when the condenser is leaking. If this is not the case, the only option is to perform...
-
ikuo78 replied to the thread 3-5 inch lift.As for the front, the stock down travel is just under 120mm. If you set this to 140mm, the upper arm or knuckle will hit the spring. In...
-
According to the build sheet today is my Jeep's 18th birthday. We went down and got her registered to vote today. Might go out...
-
Still working on the big truck, but getting closer and closer to lowering it back to the ground for a test drive with the new clutch. :p...
-
ikuo78 replied to the thread 3-5 inch lift.ARB https://arbusa.com/ https://store.arbusa.com/search-result Year=2003&Make=Jeep&Model=Liberty&Submodel=Renegade
-
ikuo78 replied to the thread Mystery P0300 root cause?.I'm sure fuel pressure may have been the trigger for activating ASD. Fuel pressure may be rising slowly. I think you should check in...
-
Bump...
-
ikuo78 replied to the thread Mystery P0300 root cause?.I think the coil, injector, and O2 sensor heater were powered by the ASD relay. Has the relay deteriorated? Usually, if a thread is...
Staff online
-
GriffinNew Member