ikuo78's latest activity
-
ikuo78 replied to the thread Need help with parasitic draw on my 2005 CRD.I think you can find circuits that are consuming power by removing suspect always-on fuses one by one and reading the change in dark... -
We removed the front drive shaft of our 2007 Jeep Liberty in August 2023 because the bearing was bad at the transfer case end of the...
-
Yup. Have driven for something like 6 months without the entire front diff also.
-
Most of the bits rotate in 2WD without carrying any power, check the front propshaft CV joint, the rubber gator often fails and lets mud...
-
-
*** solved*** The drive belt tensioner I replaced 4x months ago already failed and was causing belt slap or slip catch seneraio to...
-
ikuo78 replied to the thread New Member question about front drive shaft in 2007 Liberty.You can add grease by carefully removing the thin metal cap with a small flathead screwdriver or by removing the boot. I think boot...
-
ikuo78 replied to the thread New Member question about front drive shaft in 2007 Liberty.It seems that because it was left in the removed state, the internal seal was not crimped and it just seeped out. I think it's okay if...
-
Longtime lurker, first time caller... Or something. I was given an 05 Liberty Rubicon about 4 years ago. Long story short, my neighbor...
-
ikuo78 reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with
Like.
I put new rear brakes on and rotated tires, last night. Something’s up with the front left corner; that tire was pretty rough. A new... -
Out for a drive in the rain today doing some exploring.
-
Hello peeps! After my engine swap my mechanic decided that he should overtighten the cap on my coolant overflow tank to a point where...
-
I haven't had any trouble with the CVs, but I did drop the cradle 3/4" to help things out.
-
It's not approved by jba, but you can mount the ball joint to the bottom of the uca which moves it away from the coil, but then you must...
-
Likely uca contacting the spring. I set mine up with a piece of paper as a feeler gauge between coil and uca adjusting at clevis. It's a...
