ikuo78's latest activity
-
ikuo78 replied to the thread How To: Change front driveshaft / change a driveshaft head.Those boots tend to deteriorate easily, so I stopped attaching a boot band to the shaft side and just fastened them loosely with a nylon... -
ikuo78 reacted to DavidG91's post in the thread How To: Change front driveshaft / change a driveshaft head with
Like.
Success. Replacing the old front driveshaft with the torn TC boot and loud howl is done and there's no noise in 4wd mode. I did use the... -
ikuo78 replied to the thread “Unstable Engine Performance and High LTFT1 Reading Issue”.In most cases, a DTC will be issued and a check light will come on. If the damage does not meet DTC standards, nothing will come out...
-
Inspection all done and passed, to celebrate the Jeep rear window mechanism broke :-( This close to Christmas parts are going to be a...
-
ikuo78 reacted to CheddarGau's post in the thread Temp going up when going over 60 mph in highway for long time with Like.
Interesting. A weak cap typically releases coolant through the cap (it will also have a soft rad hose when at operating temp) vs having...
-
ikuo78 reacted to CheddarGau's post in the thread Temp going up when going over 60 mph in highway for long time with Like.
Well if your vehicle has a known head gasket leak, then you have your over heating issue..... High RPM, and in cylinder pressure can...
-
ikuo78 replied to the thread “Unstable Engine Performance and High LTFT1 Reading Issue”.Fuel trim is calculated from the O2 sensor value. It would be a good idea to replace the O2 sensor upstream of the bank that is over 30.
-
Crank angle sensor is the usual culprit, they stop working when they get hot.
-
ikuo78 replied to the thread 03 Liberty 3.7 Transmission Line Pressure Sensor Location - at a loss.Is this it? For 42, the pressure switch is attached to the valve body. There is an exposed upward facing connector on the right side of...
-
-
Completed all the welding ready for inspection today. The tin worm has eaten the sills badly, I'm putting patches over old patches, ugly...
-
ikuo78 replied to the thread Project to divert KK coil to KJ.I also replaced the saddle on my child's bicycle yesterday, but that was more expensive.
-
Cheap insurance… Good call!
-
ikuo78 reacted to belvedere's post in the thread Seized upper control arm bolt. Attempt to remove it myself, or admit defeat and take it to a garage? with Like.
Since only the tip of the blade was being used (because of access), I took the dull end off with my bench grinder and got more life out...
-
ikuo78 reacted to Hec In Omaha's post in the thread OME/Bilstein Lift for "Quackers" our 2009 KK with Like.
Howdy all! I decided to start my lift build here instead of continuing on in my other thread regarding scalloped front tires. Summary...
-
Installed my new bulbs and harness last night - the bulbs definitely have more output than the old Hella bulbs that I had previously - I...
