KJowner's latest activity
-
And of course got the freshly painted and modified skid plate installed with the 48RE/NV271 transfer case support bracket working the... -
You can call me Doctor now…Performed an blood transfusion on the NV271 :rolleyes:
-
KJowner replied to the thread AC compressor broke clutch bolt trying to turn it.The defrost will still work but demisting will be much slower without the drying effect of the ac. I'd guess that the compressor has...
-
KJowner replied to the thread I am buying a Liberty - What to avoid?.His post was in 2014.... But a helpful reply for anyone else looking for an older KJ
-
KJowner replied to the thread Crank but no start Cherokee Sport 2.4 2002... *Update: This has been solved, it was a broken Cam Belt (I won't be trusting AA diagnosis again).That's annoying! I don't know much about the 2.4, mine are both CRDs.
-
KJowner reacted to Graham C's post in the thread Crank but no start Cherokee Sport 2.4 2002... *Update: This has been solved, it was a broken Cam Belt (I won't be trusting AA diagnosis again) with
Sad.
Hi Jeeptorino68. Thanks, I've checked all the grounds and cables for continuity to the ECU, the sensors are 3 pin and I rechecked and... -
KJowner reacted to LibertyTC's post in the thread Really bad sound, is it the transmission? with Like.
My goodness that is quite the noises present there :eek: Time to drop the transmission pan & inspect filter, see if there is any...
-
Today, after finish planing 4000' of 1 x 4 rough and quarter sawn redwood in the woodshop, I walked over to the mechanics shop to keep...
-
KJowner replied to the thread Really bad sound, is it the transmission?.That sounds awful! What does the oil look like?
-
KJowner reacted to frankjc's post in the thread Rear Lower Control Arm Replacement, Lessons. with Like.
My driver's side arm was completely broken too...I wasn't dropping the gas tank either. I cut the bolt with a 4" cutoff blade. I...
-
Still working on the big truck, but getting closer and closer to lowering it back to the ground for a test drive with the new clutch. :p...
-
According to the build sheet today is my Jeep's 18th birthday. We went down and got her registered to vote today. Might go out...
-
KJowner replied to the thread Squeaking noise at 600 to 700 rpm.That's the one
-
So righty/tighty. Lefty/loose. Is that correct. Thanks bob
-
KJowner replied to the thread Squeaking noise at 600 to 700 rpm.It's a conventional thread, the fan is a nut, the shaft is threaded. I used a bit of pipe with pin jammed into one of the holes on the...
-
