KJowner's latest activity
-
No special cabling. The power amp is connected to the speaker. It sits on top of the speaker and they are joined together to the door. I... -
KJowner replied to the thread Shot intermediate shaft?.I wonder if you could just insert a spacer between the bearing and seal to move the seal out a fraction to give it a new surface to run...
-
- if it is dry, count on the shaft being damaged. There is a good parts diagram on Crown Automotive that shows the exploded view, but...
-
surely. I also end up buying low-quality products without checking. Manufacturers with IR on their HP are generally fine.
-
That spacer is for a 3.5 inch lift. It has a height of 53mm, but the clevis set position is different from the stock, so it functions as...
-
Also its important to change transfer fluid and check the chain in it
-
KJowner replied to the thread Front end wheel resistance??.You could certainly try that, if you cut the clips on the large ends of the boots you can slide them back and have a look in the joints...
-
Yeah, did figure it was mostly US, but seen some UK posters so was chancing my arm! It's Auto too by the way - forgot to add that...
-
KJowner replied to the thread What did you do to your jeep today?.Swapped the front wheels out for a set with decent tread and adjusted the handbrake, starting prep for the annual inspection. Joy of...
-
KJowner replied to the thread UK 2.8 CRD (2005) For sale.Not the best place to post I'm afraid, this is mainly American. There are a few Brits like me on here but I already own 2 of them and...
-
KJowner reacted to Hec In Omaha's post in the thread 2009 KK Jeep scalloped driver front tire with
Like.
Here are the factory instructions on how to remove the drivers side UCA. Piece of cake right? We will see! Hec -
Your spring shouldn't be pinching anything, that in itself tells you they're toast. Unfortunately spacer lift come with more problems.
-
I agree.. that spacer is going to net you more than 2.5”. Aftermarket control arms are most likely needed, but it should (barely) clear...
-
It looks like an RC 3.5 inch spacer. It is full of inconveniences when it is fully extended. I replaced it with one that doesn't have a...
-
KJowner reacted to u2slow's post in the thread best replacement when rebuilding the suspsension with Like.
Too late now. That KJ diff bracket is a new offering. My first new $80 jobber arm is still sitting standby on my shelf. 309,000km now...
Latest posts
-
-
Temp going up when going over 60 mph in highway for long time- Latest: uss2defiant
-
-
-
Staff online
-
HoosierJeeperGold Supporter/Admin