KJowner's latest activity
-
KJowner reacted to ChryslerElectronicsHater's post in the thread Driver seat lower motor assembly / electronics issues with
Like.
Best of luck to you -
There might be a computer glitch since it was the learning procedure that seemed to be the beginning of the issue. How about...
-
KJowner reacted to ikuo78's post in the thread “Unstable Engine Performance and High LTFT1 Reading Issue” with Like.
Fuel trim is calculated from the O2 sensor value. It would be a good idea to replace the O2 sensor upstream of the bank that is over 30.
-
KJowner replied to the thread Crank no Start.Any codes? Make sure everything is reattached.
-
KJowner replied to the thread What did you do to your jeep today?.Roll on spring, I hate laying on cold damp tarmac.
-
A rubber wedge shaped door stopper is my go to
-
I have a 2x4 cut to size to hold the rear window up. yes, that's in my parts bin. :D
-
I heard a new one recently: Just Every Electrical Problem
-
KJowner replied to the thread Driver seat lower motor assembly / electronics issues.What a joy! I'm planning on putting the leather electric seats from my old Limited into my slightly newer KJ Sport, luckily my wife and...
-
KJowner reacted to ChryslerElectronicsHater's post in the thread Driver seat lower motor assembly / electronics issues with Like.
An inelegant solution. 1. Remove motor square drive shaft 2. Cut rubber boot 3. Re-assemble Now the seat can be forced to move...
-
KJowner reacted to ChryslerElectronicsHater's post in the thread Driver seat lower motor assembly / electronics issues with Like.
Unfortunately it isn't. I came up with an inelegant but workable solution by cutting the rubber sleeve that protects the motor's square...
-
Your Renegade likely came with the skid plate package. Sounds like you used them! The stock Renegades were not any higher than the rest...
-
KJowner reacted to DadOSix's post in the thread How To: Change front driveshaft / change a driveshaft head with Like.
If that boot is ripped up, the joint is bad. Usually, it is the tc end and not the front one, but when I do mine, both get changed. I...
-
KJowner replied to the thread What did you do to your jeep today?.Just Empty Every Pocket.......
-
Yaaaaaa! …. but awwwww
