klc's latest activity
-
klc replied to the thread Np 231 transfer case chain.I’ve made a few purchases from them with no problems. -
klc reacted to jamesbeat's post in the thread Had a relatively minor collision. Passenger side front wheel now has negative camber and toe-out. Trying to figure out what part (or parts) got bent. with
Like.
Just an update on this in case it helps someone in the future: The problem was a bent steering knuckle. If you research this online... -
The rear shocks arrived and I installed them. Without removing the tires, Without jacking, Crawling under the car, It was frustrating to...
-
Follow up on this, the ecm module died and wasn’t sending signals to the transmission so it didn’t know what to do. Replaced the ecm...
-
Recent Commander projects: Replaced a bad belt tensioner & serpentine belt: 175 watt Inverter install: Touchscreen stereo with...
-
Those "bumps" are crush/spacers that can come off. I installed an ARB front bumper and you actually remove those and behind them is an...
-
-
klc reacted to Johnny O's post in the thread What did you do to your Jeep today? -Wrangler Edition- with Haha.
Knew I should have mounted cannon and hired a gun crew. Only in Nebraska does one have a need for full broadsides capability...
-
klc reacted to dtennes's post in the thread Misfire troubleshooting, could it be a bad IAT or IAT connector housing with Like.
Yes and no. I put over 1000 miles on the Jeep and then a misfire happened again. Pulled the IAT connector, and the #1 coil and injector...
-
I'm glad it's going well.
-
ikuo78 Thank you for making my mind go back though everything in my head. Tested all the wiring this morning and found a bad spot in one...
-
New master cylinder installed. Fyi, centric doesn't know how to drill a ******* hole apparently and thread it correctly. I wasted over 2...
-
I put in new front Jounce Bumpers. It looks like I replaced the originals on my 2003 Libby. One was gone and the other one fell out...
-
Well that was amazing. Going out there this morning and just one more time decided to try to get that nut off. Apparently sitting...
-
Although it may have been replaced, the altitude value measured by the MAP sensor is also recalled from memory at startup. I'm not sure...
Staff online
-
LibertyTCWell-Known Member