lfhoward's latest activity
-
lfhoward replied to the thread Can I Fit ANY 4.10 Gears by Just Adding ANY Steel Dana 30 Carrier into the Dana 30a “Super”?.Just for info in case people are reading this, the references to JK D30 4.56 gears in a Liberty are for the KK not the KJ. The 08-12 KK... -
Ready for seam welding & cutting in the drop to clear the fuel takeoff pot. A friend let me use his workshop so I could get on in the...
-
Yes and coat it in lots of epoxy primer and wax, it was almost in 2 bits!
-
lfhoward replied to the thread WJ tank carrier fun.Wow nice work. Will you drill holes in the new steel to let water drain out?
-
A dry morning so I've been able to clean it up a bit and tack some fresh steel in, it's so weak and flexible with all the rust I've had...
-
lfhoward replied to the thread O2 Fault Codes.The sensor end, which goes into the exhaust system, is very sensitive.
-
Yes, well sort of!
-
lfhoward replied to the thread O2 Fault Codes.O2 sensors don’t even like skin oil. You have to be very careful not to touch the business end.
-
Thanks! Just got a great rear set for $100.00 delivered!
-
the jeep has been sitting quiet in the tent with the plow on, waiting for snow.
-
lfhoward replied to the thread *UPDATED*Weird Front Turn Signal Shenanigans.Wheeee32 for the win! Love it when the solution is essentially free.
-
lfhoward reacted to wheeee32's post in the thread *UPDATED*Weird Front Turn Signal Shenanigans with
Like.
Found it! Cleaned up the chassis ground behind the drivers side lights. Running lights and turn signal blinking works again. So glad... -
lfhoward reacted to wheeee32's post in the thread *UPDATED*Weird Front Turn Signal Shenanigans with Like.
Okay I see on 8W-52-5 and -6 of the schematic the ground for both. Looks like it might be close to the right fog light...
-
lfhoward replied to the thread *UPDATED*Weird Front Turn Signal Shenanigans.I ran into it with the left turn signal. The ground wire rusted through somewhere between the housing and the ground point behind the...
-
lfhoward replied to the thread OME VS Bilstein.Also +1 for Bilstein, although I also have not run OME before. Fun fact: I am about to replace the rear Bilsteins on my 4” lifted KK...
