Are non-ABS front hubs/bearings interchangeable, or are they left/right specific?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

J

jamesbeat

Full Access Member
Joined
Feb 14, 2017
Messages
73
Reaction score
15
Location
New York
I need to replace my front passenger side wheel bearing (non-ABS). While I was shopping around, I found a really good deal on a driver's side ABS hub/bearing assembly.

While I was looking at the various listings, I noticed that the non-ABS versions appear to fit either side, whereas the ABS versions are specific to passenger's or driver's side.

Can I buy the driver's side hub/bearing assembly, clip the sensor wires off, and install it on the passenger side?
 
u2slow

u2slow

Full Access Member
Joined
Mar 6, 2012
Messages
743
Reaction score
162
Location
BC
Non-abs are the same, left vs right.
 
J

jamesbeat

Full Access Member
Joined
Feb 14, 2017
Messages
73
Reaction score
15
Location
New York
Thanks. And is it ok to use an ABS bearing on an non-ABS Jeep if I just clip the wire off, or are there other differences that make them incompatible?
 
u2slow

u2slow

Full Access Member
Joined
Mar 6, 2012
Messages
743
Reaction score
162
Location
BC
jamesbeat said:
Thanks. And is it ok to use an ABS bearing on an non-ABS Jeep if I just clip the wire off, or are there other differences that make them incompatible?
Click to expand...

I have never tried it, but I would certainly give it shot if that's the pieces I had.
 
J

jamesbeat

Full Access Member
Joined
Feb 14, 2017
Messages
73
Reaction score
15
Location
New York
Someone asked about using the ABS hubs on a non-ABS Jeep, and the consensus seemed to be that it was fine.

Front hub with ABS on non-ABS Libby

I ordered new hubs as my right front is worn, so plan to replace both of them. Found a smoking deal and didn't even think about the fact that they have the ABS sensors, and I have a non-ABS KJ. Will they still work fine, just remove the sensor? Or should I leave the sensor in place and just...
www.jeepkj.com www.jeepkj.com

I guess that also means it wouldn't matter if it was a passenger or driver side hub, since with ABS out of the equation they are interchangeable.
I think I'll go ahead and order it.
 
Last edited:
You must log in or register to reply here.

Similar threads

R
Front hub with ABS on non-ABS Libby
Replies
13
Views
2K
JeepJeepster
JeepJeepster
B
Loud sound front right even after replacing hub and removing front prop shaft - help
Replies
1
Views
2K
duderz7
duderz7
N
Wheel bearing or axle....????
Replies
14
Views
3K
NotMyRenegade
N
J
Had a relatively minor collision. Passenger side front wheel now has negative camber and toe-out. Trying to figure out what part (or parts) got bent.
Replies
4
Views
428
jamesbeat
J
P
2003 Liberty 2.4L - Is the intake manifold one piece or two?
Replies
1
Views
289
psyon
P

Random media

jeep
Kj at the Lehigh Gorge Campground
front springs and rear isos
6 inches of Snow
Glacier NP
my new toy
Steps Wet
BC4CF669-FC2F-427A-A1F5-D2EA1FDF90EB.jpeg
kens jeep

Latest posts

Members online

Total: 423 (members: 4, guests: 419)
Top