Search results
-
What did you do to your Jeep today? -Wrangler Edition-
S%^& always seems to come in a shower! Hope you have a better weekend. -
Car Handling Issues at High Speeds: Rear-End Swerves and Knocking Sound – Seeking Advice!
The knock on acceleration or braking is usually the rear upper control arm.- KJowner
- Post #6
- Forum: KJ General Discussion
-
What did you do to your jeep today?
I use an old set of Ring towing mirrors. Round our narrow roads permanently fixed big mirrors would get smashed.- KJowner
- Post #26,279
- Forum: KJ General Discussion
-
Advice please
The clutch and timing belt are service items that will need doing at some point on any car that has them, I know it's not cheap but once it's done you have years of driving until they need doing again. I bought my belt kit on Ebay direct from SKF UK and it was a lot cheaper than that, I'd see if...- KJowner
- Post #2
- Forum: CRD KJ's Section
-
-
My 2003 KJ 2.8 CRD and its problems
Is that a camshaft pin?- KJowner
- Post #30
- Forum: CRD KJ's Section
-
What did you do to your jeep today?
Do you tow that much you need to bother? I have extension mirrors that just clip on when I pull a big trailer or caravan.- KJowner
- Post #26,277
- Forum: KJ General Discussion
-
Front Axles stuck
Yes, undo the joint and split it, gently jack up the hub and pry the bottom wishbone down.- KJowner
- Post #5
- Forum: KJ General Discussion
-
My 2003 KJ 2.8 CRD and its problems
What did you get? A mercedes 2.7 one or the later Wrangler one? You need the earlier kit like this- KJowner
- Post #26
- Forum: CRD KJ's Section
-
Redid brake system but left with a problem
They are handed, left and right, they will fit in the wrong side but the bleed point would be at the bottom of the cylinder instead of the top, making it impossible to bleed the brakes.- KJowner
- Post #14
- Forum: KJ General Discussion
-
Where do the transmission cooling lines route on factory liberty CRD 2.8 diesel
The condensers has the cooler built into it, after market ones often don't! See the difference in the core. -
7" Halo LED upgrade on 2003 jeep liberty
Sadly we have an unusual size headlight and I don't think anyone makes them any more.- KJowner
- Post #2
- Forum: Detailing pictures
-
What causes oil leaks? I live in Korea
That would leak at the front of the engine and spray everywhere off the belt.- KJowner
- Post #6
- Forum: KJ General Discussion
-
ARB Bumper Discontinued
Lots of valuable spare parts on that!- KJowner
- Post #8
- Forum: KJ General Discussion
-
What causes oil leaks? I live in Korea
Check rockerbox gaskets at the top of the engine, they may be leaking and the oil running down the back of the engine, easy job to replace the gaskets. The other thing that often leaks is the rear main oil seal on the crank, big job to change as you have to take the engine or gearbox out to...- KJowner
- Post #2
- Forum: KJ General Discussion
-
2008 Jeep liberty starter problem
Take the plugs out then pop the starter out and bar the engine over on the ring gear or try a socket on the crank to turn it. See if any water comes out of the plug holes.- KJowner
- Post #2
- Forum: KK General Discussion
-
What did you do to your Jeep today? -Wrangler Edition-
Electric car drivers! -
What did you do to your jeep today?
I love my camera phone! Couldn't see that cap head anywhere and couldn't get my head in there to look.- KJowner
- Post #26,260
- Forum: KJ General Discussion
-
Vibration at 40-50 MPH 1500 to 1800 rpm
As the vibration changed with the exhaust work I'd look at that first, check it's not touching the body anywhere, sometimes old rubber hangers get stretched and let it move around, check for worn engine mounts too.- KJowner
- Post #2
- Forum: KJ General Discussion
-
My 2003 KJ 2.8 CRD and its problems
True, however paying for 10 minutes use of the diagnostic machine is cheaper than 1500 euros to buy one.- KJowner
- Post #24
- Forum: CRD KJ's Section
