Search results

  1. C

    What did you do to your jeep today?

    Yes
  2. C

    What did you do to your jeep today?

    bank 1 sensor 2 (blue) looks good for the Khaki jeep. Assuming the sensor is working properly that would be a sign of a bad cat. Your jeep doesn't look too bad. Blip the throttle a couple times in quick succession and see how long the patterns take to stabilize. The lower patterns don't look...
  3. C

    What did you do to your jeep today?

    That makes way more sense when you were talking about a special tool, hah! There is a special tool for that one, but you don't require one, just a pick or a little screw driver. If you use the screw driver method be careful, the springs will shoot off to a place you don't want it to..... and it...
  4. C

    What did you do to your jeep today?

    Unfortunately those lines are not supposed to come apart, it will need a replacement. They should be crimped and are not quick connect fittings. ***** because line replacement always means a bit of a mess
  5. C

    What did you do to your jeep today?

    When air care was still around, we would use a pressurized water mister, which was fed in through the intake. It would run through the combustion chambers, super heat and essentially steam clean everything. It works very well with clearing out combustion chambers, cats, O2 sensors, etc...
  6. C

    What did you do to your jeep today?

    That's no fun
  7. C

    What did you do to your jeep today?

    Agreed. Which scan tool are you using? I need to replace my b1s1.....heater is gone
  8. C

    What did you do to your jeep today?

    Well the transmission issue isn't a good sign. It's possible it could be a valve body issue by the sounds of it. Almost like a pressure issue, then slams into gear when it builds enough pressure. I would suggest bringing it to a shop that specializes in transmissions.
  9. C

    2004 Liberty Sport

    That is quite the bumper. Which brand is it, and how fabricating did you have to do to get it to mount up.
  10. C

    What did you do to your jeep today?

    It has a potential to work though.
  11. C

    What did you do to your jeep today?

    From what I can see in the pic it only replaces a section of the cable at the end on the shifter itself, but it's also hard to see how it will mount up without the ad.
  12. C

    What did you do to your jeep today?

    Did mine last year, but the one I ordered for my niece didn't fit, so I found a random bushing in the shop and secured it with a cotter pin. It'll hold till I get the proper one. Thats a nice looking lever. How is it supposed to connect to the existing cable?
  13. C

    What did you do to your jeep today?

    Which plastic parts? The one that clips the cable into the bracket or the bushing on the shift lever on the t-case?
  14. C

    What did you do to your jeep today?

    Did you figure it out?
  15. C

    OME/Bilstein

    Do you remember what size inside and outside diameter these are?
  16. C

    What did you do to your jeep today?

    Finally got around to installing my lift. Front end ride a little rough, but we'll see how that goes. Got the 2927.
  17. C

    What are people using for brighter headlights?

    In BC if you are importing your vehicle and have to do an inspection you will fail with LED/HID in housings without a cut off line/projector. Unfortunately I can't fail every car I see with LED and the major scatter/blinding..... until they get a VI for something else..... then they're mine
  18. C

    What did you do to your jeep today?

    4 WHEEL ABS is a very euro way of getting tpms. Pretty effective and low cost and nothing to break. You can likely thank Mercedes for out smarting you on that one :)
  19. C

    What did you do to your jeep today?

    Your signals run through the hazard switch, then output to the BCM, through a couple relays and down to your signal wiring and the bulbs. Your entire circuit is good after the hazard switch. That leaves the multi function switch and the wiring between the switch and hazard switch. It's far more...
  20. C

    What are people using for brighter headlights?

    Any issues with heat melting the housing?

Random media

DSC00877 (Large)
Jeep Pioneer stereo
After Lift
First Day I drove it home
Front View w/o Flares
DSCF1003
avatar4
Yes, I was snorkeling in the infinity pool. I am a dork.
On the road

Latest posts

Members online

Total: 388 (members: 3, guests: 385)
Top