Search results
-
X
P0340 - fishing for ideas
I had a bad MAP sensor (sits between A/C in the front on intake manifold) was running bad spitting out different codes, good luck- Xterra4x4
- Post #4
- Forum: Electronics
-
X
Advice/recommendations
I have a 2004 4x4 liberty, replaced the ****** with rebuilt one, just an idea I moved trans cooler up into the airflow, as old layout put the cooler below the bumper out of the airflow. After my ****** ran 30 degrees cooler- Xterra4x4
- Post #5
- Forum: KJ General Discussion
-
X
2002 Jeep Cherokee KJ 3.7L V6 Petrol Spluttering, sounding like a diesel!
Have you used a good fuel injector cleaner? Like Chevron/techron?- Xterra4x4
- Post #6
- Forum: KJ General Discussion
-
X
Can someone help me identify these lines?
What ype of fluid is it leaking?- Xterra4x4
- Post #12
- Forum: KJ General Discussion
-
X
Confused by part description.
Your rig sounds lifted to! Did you do it or shop and what parts?- Xterra4x4
- Post #10
- Forum: KJ General Discussion
-
X
Confused by part description.
Dorman part #946386 rear driveshaft cost about $700. you could save and remove driveshaft and have ujoints replaced!- Xterra4x4
- Post #8
- Forum: KJ General Discussion
-
X
Confused by part description.
On my 2004 the front drive shaft needs to be rebuilt, maybe send yours out! You can drive without it.- Xterra4x4
- Post #5
- Forum: KJ General Discussion
-
X
Confused by part description.
Have good experience from Rockauto buying, I've replace my Liberty Renegade ujoints once, bought them from auto zone and beat them out,made jig out of 2x6 drilled hole in 2x6 sat there and beat them out, or pay a driveshaft shop $100, goodluck- Xterra4x4
- Post #2
- Forum: KJ General Discussion
-
X
Wheel bearing or axle....????
Snow and water is a killer of bearings and u-joints. If you need to buy parts I use Rockauto for most all my parts, it give you many price option to choose from, and I'm assuming you have no garage to work on cars in Ontario, Canada, my home country by the way. Born in Toronto, rasied up in...- Xterra4x4
- Post #14
- Forum: KJ General Discussion
-
X
Transmission system overheating
Good luck on yours, with what ever you do!- Xterra4x4
- Post #20
- Forum: KJ General Discussion
-
X
Can someone help me identify these lines?
Follow the lines, they appear to be lines to the heater-core, transmission lines run between ****** along oil pan to the front of the motor,then to ****** cooler!- Xterra4x4
- Post #10
- Forum: KJ General Discussion
-
X
Its time I introduced myself.
I've done my own maintainance work on all of my 4x4s, the only way I now it done right, My Lib came from the Portland , Ore. area and u-joints and bearing go first. My lib has 162k bought with 136k and did a lot of work. New radiator-hoses-water pump-resivoir, new heater-core, new automatic...- Xterra4x4
- Post #5
- Forum: KJ General Discussion
-
X
09 Limited - No air out of Dash Vents
Wasn't sure if 2009 is vacuum or electric? My 2004 is vacuum.- Xterra4x4
- Post #4
- Forum: KK General Discussion
-
X
Its time I introduced myself.
How many miles are on your Lib? Also do you do your own mechanical work?Lastly check the U-joints!- Xterra4x4
- Post #2
- Forum: KJ General Discussion
-
X
09 Limited - No air out of Dash Vents
It probably is a vacuum leak, Under the radiator resivoir tank is a vacuum line junction where the line for the inside car plugs in check there!- Xterra4x4
- Post #2
- Forum: KK General Discussion
-
X
Can someone help me identify these lines?
Lines to heatercore- Xterra4x4
- Post #6
- Forum: KJ General Discussion
-
X
Wheel bearing or axle....????
W What year? Also did you check the U-joints on the drive shaft?They can make a low pitch hum- Xterra4x4
- Post #7
- Forum: KJ General Discussion
-
X
2004 Liberty Control Shift Cable
I needed to find a bushing on the end and improvised to work, good luck- Xterra4x4
- Post #11
- Forum: KJ General Discussion
-
X
New Plugs/Coils now strange idle
Well after plug and coil replacement it takes a few secondss for computer to reset!- Xterra4x4
- Post #6
- Forum: KJ General Discussion
