Search results

  1. tommudd

    265-70-16?

    perfect that is what I run on the 03
  2. tommudd

    2012 KK Lift Medium Springs for Rear

    Not going to sit level , will need to add some in the front to level it out
  3. tommudd

    265-70-16?

    yes , most likely if 265 70 16s what wheel , width and backspacing ? all comes into play
  4. tommudd

    What did you do to your jeep today?

    MOPAR thermostat I hope
  5. tommudd

    this has not been a good day for me- broken JBA UCA

    Back in the days of Al Handy ( the original JEEPIN BY AL ) yes , and the very early JBA arms I had two sets of those Then Marlin took over manufacturing them for Al then bought Al out
  6. tommudd

    What did you do to your jeep today?

    No longer sway bar links are needed , I ran over 4.5 inches for way over 100,000 miles with stock length links and no issues at all Pound over the pinch welds in front and 245-75-16s will be tight but work at 2.75 inches of lift just be prepared for a little drop in mileage and power I can...
  7. tommudd

    2012 KK Lift Medium Springs for Rear

    There NEVER was a Heavy Duty rear spring from OME for the KJ or KK Not sure what you had but only mediums and light duty for the KK 2730 is light duty and medium is 2731 And you are using 132Ls with wanting a light duty spring ?? 132Ls were for higher lifts than what you will need , Do you...
  8. tommudd

    What did you do to your jeep today?

    On the front , just loosen clevis bolt, using the end of a 3/8 inch extension, raise that amount and tighten down and done
  9. tommudd

    What did you do to your jeep today?

    should only of been one end
  10. tommudd

    245/75/r16 vs 235/75/r16

    thinner. wider, not enough to really notice I ran 265 to 16s and 265 75 15s and got the same mileage as one with 235 70 16s
  11. tommudd

    245/75/r16 vs 235/75/r16

    below
  12. tommudd

    245/75/r16 vs 235/75/r16

    ny wheel spacer sits the wheel/tire combo out further which in turn will cut the radious of how much you can turn
  13. tommudd

    Bilstein 33-185552 Shocks Sleeves

    DO NOT BUY THE 5100S Anyone thinking or wanting to use the Bilstein 5100 adjustable front shocks , think again If you do want to use them, not sure why but,..... You should not install them any more than sitting at the 0 mark, that is it Any higher and it will create a disaster , degrading the...
  14. tommudd

    Bilstein 33-185552 Shocks Sleeves

    Yes the sleeves go in one end of the bushing
  15. tommudd

    Front receiver hitch

    Stand back That is what almost to the word 3 of the folks said before their KJ they were winching up over different hills said before ......BAM LOL
  16. tommudd

    245/75/r16 vs 235/75/r16

    XJ and a KJ is two completely different animals no way you can say a XJ does ok so a KJ will as well
  17. tommudd

    245/75/r16 vs 235/75/r16

    Wheel spacers will make it worse in front Pound over your pinch weld in front Plastic liner gone, sad does not help a bit in tire size only has big pockets to collect dirt etc now to rust more 245 75 16 will work, just know you will lose some power and mileage especially when pulling any...
  18. tommudd

    p0138 help! changed o2 twice and still reads code

    What brand of 02 sensors , these things only like certain brands better quality ones does not say brand
  19. tommudd

    Front receiver hitch

    They do make them but your only rated for what the hitch and pin is.So if you have a 8000lbs winch your safety rating using the hitch mount is only 5000lbs and not enough to safely extract a stuck KJ. And yes I have seen them fail big time so you are just lucky so far
  20. tommudd

    Rust hole in the floor. 2006 Liberty.

    On two of my old Bob Tail Broncos I just used stop signs, worked great, bent , bolted them down after painting floor with black roof cement One of my dune buggys had large turn signs as floors , Highway Patrol laughed when they inspected it

Latest posts

Members online

Top