Nice looking pile-o-parts
Can you measure the height of the poly puck on the front assembly for me? Take the highest and lowest measurements of the spacer puck.
What generation A arms did you get?
That KJ of yours is going to be lookin good when you and Jennifer get it done.(woot)
This picture might not be the best quality!
I just bought a new graphics tablet and I was just playing with it.
Anyway...
The lowest part of the polyurethane spacer puck is 1 inch (Where the end of the coil spring meets the spacer puck) and the maximum hight is 2 1/16 inches. (One full coil of the spring.)
The Al's Upper Control Arms are Generation 4.5
That's a fancy Wal Mart....I can tell you that much.
I excited for you about the results.
Yeah, The first Supper Centre in B.C. Something like 125,000 square feet! Grocery store, no beer or wine though and no guns either!
Now I have to wait for the tires to come in. Once they are here, Jen and I will be busy!
I can't wait! But I will, because I'm not going to drive around a lifted KJ with 225-70-16 inch tires! That would just be ********!screwy.gif
That would constitute me being called a poser!hah.gif
The best store is the Futureshop in the back ground of the first picture
That's my most favorite special bestest store ever.\\
/nana.gif
Electronics store...hehehehe.
A Huge one at that!
Holy cow...time to wash the brake dust off those front wheels my man...
I know I know!
My brain works, but my body hasn't been co-operating all to well for the last month unfortunately!](*,)
He doesn't need to paint that wheel black for sure!!!
Ya Ya!8-[