Latest activity
-
Sometimes when I go to turn the key before starting I get like 3 to 4 check engine light flashes but nothing after that is this a... -
Aatikovi replied to the thread Rear suspension or axle clunk when getting on or off the gas..OK I'll take a closer look tomorrow.
-
RRonP replied to the thread What did you do to your jeep today?.Sometimes you can't get them to stop leaking without using the u shape with the two wings so it pulls down on more of the cover. Old...
-
Sis this turning into a show off your IRO?... Or did I totally miss the social que?
-
Cis this turning into a show off your IRO?... Or did I totally miss the social que?
-
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).is this turning into a show off your IRO?... Or did I totally miss the social que? -
-
duderz7 reacted to u2slow's post in the thread Rear suspension or axle clunk when getting on or off the gas. with
Like.
Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the... -
duderz7 replied to the thread Rear suspension or axle clunk when getting on or off the gas..Jack it up by the axle so it's closer to ride height during inspection. The bushings mentioned would be a good place to start, next the...
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the... -
Aatikovi posted the thread Rear suspension or axle clunk when getting on or off the gas. in KJ General Discussion.New to me 2006 6-speed with 180,000 miles. Whenever I even lightly step on the accelerator or take my foot off it, I hear and feel a...
-
RRobochop replied to the thread Overheated now this!.I would agree with seafish. Coolant is probably getting into the system making your oil very creamy. Depending on your current mileage...
-
Oosbro168 replied to the thread Suggestions for A/C clutch?.I got the china clutch works good been about 5 years now
-
Oosbro168 replied to the thread Suggestions for A/C clutch?.
-
Do you have room to hammer your torx bit driver on the stripped screw? If so, you can try using a piece of tin foil. Fold it so you... -
CCheddarGau reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with Love.
It can’t be tight if it’s liquid…
