duderz7
Latest activity Postings About
-
-
That definitely is not for a Liberty - probably just used a stock photo for the listing I would guess. -
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).It's pretty minimal, there's not much those rubber bushings can soak up. They're designed to be running at a lifted height. The bushing...
-
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).I'm running the flex joints you definitely hear and feel more vibrations and road noises, but it's not much and you know what it is so...
-
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).I have replaced the ball joint and bushings in the stock before and it performed well and has lasted until I put the IRO on. I can tell...
-
duderz7 replied to the thread Jeep Liberty Brake and Rotor Question.Flush new fluid through before replacing caliper, that way old fluid never gets in new caliper.
-
Front flex brake hoses. Gyro
-
duderz7 replied to the thread Front Lower control arm and steering knuckle modification.2005 is KJ. KK started in 2008
-
duderz7 replied to the thread Control arms lift kit.Up to 3 inches the stock arms still work.
-
duderz7 replied to the thread Blown OME - Moving to Bilsteins.4600 and 5100 are the same except color.
-
Omg yes I followed your winter gear swap. That had to have been brutal. Maybe in my younger years…lol By the way Rene_05 that is a darn...
-
duderz7 replied to the thread 4.10 Re-gearing - 2025.When you're doing it outside in an Idaho winter you don't take as many pictures as you should, but I do have a thread of my build on...
-
duderz7 replied to the thread 4.10 Re-gearing - 2025.When I did my calling around every place I spoke with wanted the rear axle to remain in the Jeep during rebuild. And that is how I did...
-
duderz7 replied to the thread 4.10 Re-gearing - 2025.I'm near Ontario Oregon, if you end up going after yourself I have the bearing puller needed for the carrier and pinion bearings as well...
-
duderz7 replied to the thread 4.10 Re-gearing - 2025.It's not too bad to do yourself if you have time and patience. You might have to pay a shop to remove old and press on new bearings on...
-
duderz7 replied to the thread 4.10 gear finally Installed.I did mine myself.I have a thread on here somewhere. It's quite a project. I feel the most important thing is to have plenty of time and...
-
-
Loading…
-
Loading…
