C
CheddarGau
Latest activity Postings About
-
-
CCheddarGau replied to the thread New Jop, what should I do to it next?.I swapped out the rear bilstein 5100 shocks for Monroe load control (shock with a spring around it) and it brought the rear in line with...
-
CCheddarGau replied to the thread What did you do to your jeep today?.This style is common on newer vehicles. Basically plastic. Never seen one fail other than the ball joints.
-
CCheddarGau replied to the thread Coolant leak, full resevoir gone in 24 hours, should I replace water pump?.Looks like you can go and do a water pump. Generally comes from the pulley shaft or the paper gasket. Slam a new one in and move on with...
-
CCheddarGau replied to the thread What did you do to your jeep today?.I wouldn't feel too bad about it. Happens more than you would think on many brands. Ford 3.0L and 2.0 and 2.5 are bad for it. Honestly...
-
CCheddarGau replied to the thread Coolant leak, full resevoir gone in 24 hours, should I replace water pump?.If the leak is pretty bad fill with water, run it and then let it sit once on the warm side. If it's a bad leak you will see the water...
-
CCheddarGau replied to the thread Rear Upper Control Arm (Boomerang).Hmm that's a tough call. Ride pretty noisy as it is. Don't want to have to crank my radio more..... but strength and longevity...
-
CCheddarGau replied to the thread More Information Regarding Kj Renegade Roof foglight mounting.So not having the wiring isn't the end of the world. I would have to look up what the factory harness looks like, but most likely has a...
-
CCheddarGau replied to the thread removal of transmission in a day, is it possible?.Pushing torque converter towards the transmission once separated will keep it from leaking. Assuming you don't tip transmission forward...
-
CCheddarGau replied to the thread Rear Upper Control Arm (Boomerang).Anyone use the IRO upper control arm with the flex joint? If so how much more interior noise was there?
-
CCheddarGau replied to the thread removal of transmission in a day, is it possible?.Typed in "jeep liberty transmission removal" and this is the first thing that pops up...
-
CCheddarGau replied to the thread removal of transmission in a day, is it possible?.Cut everything that's in your way in that case. Unbolt starter, remove ring gear bolts, remove trans mount and remove bell housing bolts...
-
CCheddarGau replied to the thread Looking the upgrade my suspension on 2005 jeep liberty.Bilstein shocks are amazing. Replacing with new springs will also give it a great ride improvement.
-
CCheddarGau replied to the thread Bert is in my driveway...won't start....I personally do not like NAPA parts. They are expensive and like to use the cheapest suppliers and re-badge it. Good work verifying it.
-
CCheddarGau replied to the thread removal of transmission in a day, is it possible?.Usually the service info is good. In many cases not taking short cuts greatly speeds up the job. Pull the transfer case off first in...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.More layers, 10 vs 4 or 6 depending on tire.
-
-
Loading…
-
Loading…
