KJowner's latest activity
-
KJowner reacted to joshgoble's post in the thread Replacing the 3.7 with a M111.973 2.3 L with
Like.
That's a good question I'm not sure. But I'm hoping that the engine mounting plates are identical because this is kind of what I've... -
drove it and my son to go do this. good times!
-
KJowner replied to the thread Replacing the 3.7 with a M111.973 2.3 L.This sounds interesting! I think a manual gearbox would be easier unless a stand alone gearbox controller is available? Or is your...
-
Also - please be aware that just because the dash lite says you are in 4, or part time, does not necessarily mean it is so. The...
-
probably not the same, but mine was doing this with 80K miles for the previous owners so they traded it in on new jeep. I bought it off...
-
KJowner replied to the thread Hazard lights flash when right turn signal is flashing.Sounds like a bad earth to the light unit.
-
Front regulator: Has a wide nylon clip Rear Regulator: Has a narrow nylon clip to hold the window. I can’t make my picture paste over...
-
KJowner reacted to Actarus-Euphor's post in the thread 2003 KJ - fail of 4wd for a short time. with Like.
OK, I thought wrong, Oops
-
KJowner replied to the thread 2003 KJ - fail of 4wd for a short time..No the Jeeps never had freewheeling hubs fitted.
-
KJowner replied to the thread What did you do to your jeep today?.Much easier.... if you can find one, they were only fitted to the 2.4 4 cylinder and the 2.5CRD. Last one I bought turned out to be...
-
KJowner reacted to JustSumDad's post in the thread 2003 KJ - fail of 4wd for a short time. with Like.
thats really weird to me, but I dont actually know how the tcase is setup... I thought the lever ran a cable direct to the tcase...
-
Went to the dealership today to retrieve a freeze plug. 6034804AB is the part number if anyone ever needs it. The plug is a perfect fit...
-
Put it together just fine, but check this out. In rust we trust!
-
KJowner replied to the thread 2003 KJ - fail of 4wd for a short time..Mine sometimes needs a nudge of reverse to get it to drop into 4x4, probably a bit sticky from lack of use.
