KJowner's latest activity
-
KJowner replied to the thread 2005 CRD cranks but won't start after rolled on side.There should be a hand pump on the fuel filter body & a bleed screw, open the bleed and pump until fuel without bubbles comes out, then... -
-
Nope … it’s still a Fiat ;)
-
Looks great. You will like the 4:10’s. I have them with a locker in the rear. Love it. I run those wheels too. This set of 5 tires...
-
KJowner replied to the thread 2005 CRD cranks but won't start after rolled on side.I don't think there is one. Is the fuel system still primed?
-
KJowner replied to the thread WJ tank carrier fun.Yes and coat it in lots of epoxy primer and wax, it was almost in 2 bits!
-
KJowner replied to the thread WJ tank carrier fun.A dry morning so I've been able to clean it up a bit and tack some fresh steel in, it's so weak and flexible with all the rust I've had...
-
-
Thanks! Happy to be here! I'll be honest I was very surprised at just how well it handled in not just the snow but the two inches of ice...
-
KJowner reacted to prboy1969's post in the thread HOW TO: Keep your Fog Lights ON with High Beams with
Like.
Thanks "myjeepwalks" for the original write up. I highly appreciate it. Also, thanks "jeeptorono68" for reposting the original pdf. -
KJowner reacted to jeeptorino68's post in the thread HOW TO: Keep your Fog Lights ON with High Beams with Like.
You are in luck! I saved it. attached below
-
I am doing it at present, the 2006 that I am working on has clips, you need a pick to remove them, and a pair a needle nose pliers, take...
-
Try this one. Yes it will ship to UK from Ebay...
-
Rain finally stopped for a day so I took advantage and picked up a sheet of steel & then dropped the tank carrier off, annoyingly it has...
-
-
KJowner replied to the thread Window regulator clip 3d print.The page is blank? Do you ship to the UK?
-
I sell the OE replacement kits for a few different versions. These are the upgraded Mopar kit to fix the issue with these breaking...
-
KJowner replied to the thread Rear axle question.I assume they are both the same axle casings? Check the diff ratio is the same or you will have a nasty surprise if you select 4x4
