CherokeeLiberty
Full Access Member
It can’t be tight if it’s liquid…xc_hide_links_from_guests_guests_error_hide_media
Today I bought a 22 mm wrench and a Bernzomatic torch with the yellow MAPP gas canister. I will no longer be asking nicely.
What did you do to your jeep today?
- Thread starter TheQ
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The valve cover is still dripping oil.
I removed the grommet from the mounting bolt and checked the tightening, but it was only compressed by 0.5 mm.
Perhaps a plastic valve cover grommet was included by mistake.
The grommet was only 5 mm thick.
While I wait for the plastic cover to arrive, I am observing it with a 0.5 mm U-shaped shim sandwiched between the grommet.
It is a mystery whether the bolt sleeve is crushable.
It probably will not seat at the specified torque, so it may be crushed to protect the head threads in the event of excessive torque.
I removed the grommet from the mounting bolt and checked the tightening, but it was only compressed by 0.5 mm.
Perhaps a plastic valve cover grommet was included by mistake.
The grommet was only 5 mm thick.
While I wait for the plastic cover to arrive, I am observing it with a 0.5 mm U-shaped shim sandwiched between the grommet.
It is a mystery whether the bolt sleeve is crushable.
It probably will not seat at the specified torque, so it may be crushed to protect the head threads in the event of excessive torque.
You must be registered for see images attach
You must be registered for see images attach
