LibertyTC's latest activity
-
Check rockerbox gaskets at the top of the engine, they may be leaking and the oil running down the back of the engine, easy job to... -
Repair too complex for this old person, so I bit the bullet, took it to the shop, got a super flush and new heater core. Working good...
-
LibertyTC reacted to KJowner's post in the thread Redid brake system but left with a problem with
Like.
If the brakes are soft then you still have air in the system, possibly trapped in the ABS unit if you have drawn air through there. Did... -
LibertyTC replied to the thread Engine light 2004 Liberty.I'd also like to mention that short trips can make the KJ unhappy as the stock pcv valve, can become plugged up with a yellowish foam...
-
-
I have a 04 Liberty 3.7 6cyl. with 75,600 miles. Got an engine light a couple of months ago---P-0128. I have since replaced the engine...
-
LibertyTC replied to the thread Engine light 2004 Liberty.This code means that the engine did not warm up to 180 degrees in 10 minutes after startup. Could be the thermostat is stuck open? Try a...
-
-
I just wanted to introduce myself! My name is Dawna. I'm neither new to Jeep nor forums but this forum and the Liberty are new to me. :)...
-
Thanks for your reply. Will fix it correctly!
-
LibertyTC replied to the thread Stop Leak question.Not good at all. No quick fix here. The leaky heater core is a big job & you don't want to breathe the misty coolant vapor. Make...
-
LibertyTC reacted to jamesbeat's post in the thread Had a relatively minor collision. Passenger side front wheel now has negative camber and toe-out. Trying to figure out what part (or parts) got bent. with Like.
Just an update on this in case it helps someone in the future: The problem was a bent steering knuckle. If you research this online...
-
Clockspring is usually at fault with a short like this.
-
So I discovered my horn doesn't work on my 2002 Jeep Liberty Limited; when I press the steering wheel or when I set the alarm. I...
-
LibertyTC replied to the thread Had a relatively minor collision. Passenger side front wheel now has negative camber and toe-out. Trying to figure out what part (or parts) got bent..Probably best to have an alignment shop inspect it closely.
-
LibertyTC replied to the thread Need help identifying these control arms so i can refurbish them and replace the ball joints..Jeepin by Al's upper ball joints information..:)
-
Latest posts
-
-
-
-
Temp going up when going over 60 mph in highway for long time- Latest: uss2defiant
-