I created some .DXF files for wrenches for people to use. These wrenches are designed to fit the Iron Rock upper and lower control arm nuts. They have a 1/2 square for a breaker bar or ratchet. No analysis was run on these for stress/strain, I just made what I thought "looks" right in a few min of 3D modeling. I tried them on on my Jeep and they worked great. These are much smaller than packing a very large adjustable wrench in the tool kit.
These were made from sendcutsend.com on 1/2 thick HRa36/1008 Mild Steel.
Large Wrench for upper control arms ~56mm Hex
Small Wrench for lower control arms ~47mm Hex
Legal note: 65Corvair is not liable or responsible for damage or injury that may occur when using this product. It is up to the end user to use common sense when using the wrenches.
These were made from sendcutsend.com on 1/2 thick HRa36/1008 Mild Steel.
Large Wrench for upper control arms ~56mm Hex
Small Wrench for lower control arms ~47mm Hex
You must be registered for see images attach
Legal note: 65Corvair is not liable or responsible for damage or injury that may occur when using this product. It is up to the end user to use common sense when using the wrenches.
