Search results
-
front axle pieces parts
Your NAPA does not stock or can get ? Interesting I went to local NAPA , told them what I wanted and had it next day This was just last week for a customers ride but no issues- tommudd
- Post #13
- Forum: KJ General Discussion
-
Change Oil Message
KK or KJ KJ is easy KK can be very hard- tommudd
- Post #4
- Forum: KK General Discussion
-
Help with rear driveshaft/diff
How are the U Joints first thing ? Looks alone doesnot tell how they are Take it for a ride 20/30 minutes , pull back and stop and put hand near each u joint , if hot it is bad Next check backlash in rear diff Then- tommudd
- Post #2
- Forum: Technical Service Bulletins and Recalls
-
Transfer case swap
yes the lever as well or how would you know which position you are in Why are you swapping them ?- tommudd
- Post #2
- Forum: Announcements & Support
-
Change Oil Message
No you have to reset message after you change your oil Oil filter is in a great spot I change oil in mine and customers all the time, reach up in and remove/ replace , easy- tommudd
- Post #2
- Forum: KK General Discussion
-
Power steering Level
DUH, marks on the side of it , clearly visible if you wipe it down, plus most are raised letters- tommudd
- Post #13
- Forum: KJ General Discussion
-
front axle pieces parts
che cheaper ? If you feel like gambling maybe I have a ton of CVs and Intermediate shafts here , would never use them again- tommudd
- Post #8
- Forum: KJ General Discussion
-
front axle pieces parts
ORDER NEW CV AND INTERMEDIATE SHAFT NOW You do not want to mess up the new bearings CV from NAPA, remanned one, take old one in for a trade in- tommudd
- Post #7
- Forum: KJ General Discussion
-
sleepy jeepy
Just read, ask questions and do it right the first time I bought my 04 brand new , went through 4 lifts / testing/ beating etc , front and rear aftermarket bumpsers, roof rack etc etc etc Wife never did know how much I spent, well enjoyed LOL Over 233,000 miles and someone offered me almost as...- tommudd
- Post #4
- Forum: Introductions
-
Power steering Level
Well then it would have marks on the side of it to show- tommudd
- Post #10
- Forum: KJ General Discussion
-
Thermostat Upgrade
nope now you are messing with computer etc as well racing thermostat LOL- tommudd
- Post #2
- Forum: KJ General Discussion
-
Drip line closed off
DRIP LINE ? That is the condensation line for the AC , it will drip some out when running the AC and you blew air up into it ? Ok now- tommudd
- Post #2
- Forum: KJ General Discussion
-
First Post
Be 69 in August, and Im still doing lifts on all makes of 4x4s ( on the ground ) no lift OLFs , tune ups etc Working keeps ya young LOL- tommudd
- Post #7
- Forum: Introductions
-
KK Rock Sliders
Too bad not around any pipeliners When they were installing gas lines from all the oil wells they drilled around here, I needed a couple of things welded Mine wasnt hooked up, got one of them I met at the gas station and a six pack for about 20 minutes of burn time came right to the shop with...- tommudd
- Post #9
- Forum: KK General Discussion
-
-
2012 KK Lift Medium Springs for Rear
S since you NOW are going with the 731s in the rear which gives more height you can use the 132Ls with the 926s it will have a rake front to rear- tommudd
- Post #5
- Forum: Lift Kit Discussion
-
KK Rock Sliders
Yes would not much time to cut them off then to reweld new bar on would be less than an hours time- tommudd
- Post #6
- Forum: KK General Discussion
-
What did you do to your jeep today?
Even on the main hiways its good to have I have hit ladders, transmissions and other junk that would of taken out my transmission if not for a sjid plate- tommudd
- Post #23,982
- Forum: KJ General Discussion
-
Indiana Trails
Only one I would go to is the Badlands Haspin was nothing but a mud pit Redbird about the same Interlake is a cool place but mainly what I drive on daily in Southeastern Ohio . not really a 4x4 place- tommudd
- Post #10
- Forum: Serious Offroad Trips, Trail Rides, and Meets
-
KK Rock Sliders
I have personally seen RRO sliders bend very easily before on a KJ Same spot I had just gone across and when that guy followed my exact tracks his bend easily have way through I only had a couple of scratches I would find a really good fab shop to replicate the Rock Lizard ones but that is just me- tommudd
- Post #2
- Forum: KK General Discussion
