Search results

  1. C

    2003 Jeep Liberty Driver Side Window Issue

    Would you mind linking me to that?
  2. C

    2003 Jeep Liberty Driver Side Window Issue

    Wondering if anyone can offer any insight to my issue. So the driver side window in my 03 Limited goes down about 25% then when I try going any further there is a grinding noise and it does not move any further and seems the motor just spins until I roll it up again, when I roll it up the motor...
  3. C

    2003 Jeep Liberty Concerns

    Thank you for your input! I got word back today the leak was coming from the timing chain cover. It is being actively fixed & I should get word back soon, thanks!
  4. C

    2003 Jeep Liberty Concerns

    I will be honest, I did not think I would have to re-visit this post. So after getting the U-Joint replaced which did go well we noticed that there was oil accumulating on the underside of my Jeep, after looking closer its hard to tell exactly where its coming from. I am posting a few pictures I...
  5. C

    2003 Jeep Liberty Concerns

    Thank you for all this information as it has been extremely helpful! It was in fact the U Joints, they have all been replaced & all is well now, no more noise! While under my Jeep there was a noticeable oil leak coming from the timing cover, I am taking it back to the service center to have it...
  6. C

    2003 Jeep Liberty Concerns

    Thank you both for your advice and I will have a look first thing tomorrow, I do not know exactly where to look for the greese on the CV Joint but I will find a diagram, so if this is not something that will be taken care of until early next week is the car okay to drive until then? I can try...
  7. C

    2003 Jeep Liberty Concerns

    So my Jeep has been great since I have gotten it back but since I have gotten it back I noticed a slight quiet squeaking noise when driving on 1 way roads with cars on both side or a jersey wall & today when reversing it almost sounds like seagulls squalling underneath. I called she shop and...
  8. C

    2003 Jeep Liberty Concerns

    I have put about 200 miles on my Jeep & still not check engine light & the rough idle is gone & all is well, my Jeep is driving like new & better then before all this happened, thanks again especially HoosierJeeper for the guidance on this & everyone else for the advice! I am hoping to have my...
  9. C

    2003 Jeep Liberty Concerns

    I wanted to post a update since I have my Jeep back now. So I got it back today & drove about 80 miles & not only is the rough idle gone but no check engine light! The service center said something about the fuel trim being adjusted but did not go into detail, it drives better then ever so I...
  10. C

    2003 Jeep Liberty Concerns

    HoosierJeeper summed it up pretty nicely, basically they tried to talk me into thinking they could fix the issues with dropping the oil pan and replacing the oil pump but that was not the issue at all so in between them admitting it needed a new engine I picked it up a total of 4-6 times and...
  11. C

    2003 Jeep Liberty Concerns

    So good news, when they reviewed the live data today they informed me the fuel trim and something else was off, they are doing something called a full drive cycle where they drive the car, let it sit for 8 hours, then finish the configuration. They informed me that this is something that happens...
  12. C

    2003 Jeep Liberty Concerns

    Dang it is actually with a friend right now and I have both downstream sensors in the car ready for replacement, I just called him & he said he plans to put in the sensors in the next half hr. So you think this seems improbably that they would all be failing at the same time? The service center...
  13. C

    2003 Jeep Liberty Concerns

    So I just spoke with the service center again and they informed me that the codes that were thrown are P0138, P0158, & P0151, the codes were cleared out but today when they re-ran the check there were 3, the first time the code was P0138, I am assuming I should replace both downstream. I was...
  14. C

    2003 Jeep Liberty Concerns

    So it is downstream bank 1, so yea the idle was pretty rough ever since I got it back, I am wondering if there could be another underlying issue there because the idle was pretty smooth before I put it in there? Just to note I only drove it about 30 miles before I had to put it back in to get...
  15. C

    2003 Jeep Liberty Concerns

    Okay thank you, I am going to pick the sensor up today. I will report back once it is in, could the sensor be contributing to a rough idle on a cold start? I noticed that once I got the car back. Also they are calling me back with the code it threw and also which stream the sensor is. I got a...
  16. C

    2003 Jeep Liberty Concerns

    Sorry did not mean to sound confusing, I meant whichever it is upstream or downstream would it be better to do the left & right sides of the stream even if only 1 side if defective (2 sensors replaced)? Or would it only make sense to do the 1 effected sensor only. Thanks!
  17. C

    2003 Jeep Liberty Concerns

    So would the left side bank be downstream? If so should I just do both downstream at the same time?
  18. C

    2003 Jeep Liberty Concerns

    Thanks you! I can not thank you enough for your guidance and help through this, it has been invaluable to me. They basically said there was nothing they could have possibly done to cause the sensor to go bad, they said that if the unexpected things such as the fuel line system, gaskets, and...
  19. C

    2003 Jeep Liberty Concerns

    Thanks for the advice! They have NTK at my local advance auto for about the same price as the NGK onces on amazon, just curious why did you only do the downstream and not up? If one goes out is it really not warranted to do them all?
  20. C

    2003 Jeep Liberty Concerns

    So I am getting the code cleared out & my jeeps grille has been painted, I did notice that it was idling kinda rough for the short time I had it back which I read could be related to the o2 sensor going bad. They are unwilling to work with me on the o2 sensor due to the magnitude of work they...
Top