Search results

  1. C

    Radiator getting replaced need advice

    When I get it replaced it will be getting the correct coolant added. Just because of the cost I was hoping to at least be able to wait a couple weeks.
  2. C

    Radiator getting replaced need advice

    Ok thanks for the help and confirmation on that. When I've checked the coolant it looks brown. I haven't had any overheating issues at least.
  3. C

    Radiator getting replaced need advice

    I am getting my radiator and hoses replaced tomorrow. It cracked at the top on the drivers side. I know I can do it myself and have done it before but the weather is a little too cold out to do it myself and I don't have a garage to work in. An issue I have is that regular coolant was used to...
  4. C

    Tapping noise at low speed

    Well I put it on jack stands and could not find any issues. I brought it to the garage and they couldn't find any issues either. I can say though the front drive shaft is fine. It doesn't make any noise while turning and only when going straight at about 20 mph. Even then it tends to be a...
  5. C

    Tapping noise at low speed

    Thanks!
  6. C

    Tapping noise at low speed

    Can I also just jack up the front end and spin the wheels will the engine is off and it's in 2wd to listen for the noise?
  7. C

    Possible Recall 2002-2007?

    I didn't get an appt but am on a waiting list now.
  8. C

    Tapping noise at low speed

    How can I check the left and right cv axles?
  9. C

    Possible Recall 2002-2007?

    Still have not received my actual notice. I have only received the prenotice.
  10. C

    Tapping noise at low speed

    I will check out the cv. The front driveshaft has already been replaced and I checked the boot again and it's intact.
  11. C

    Tapping noise at low speed

    When coasting at a low speed I hear what sounds like a tapping noise coming from the front end. It only happens in 2wd and stops if I apply the brake or gas. It sounds like a pebble in the tire treads.
  12. C

    New tires

    I have decided on the discoverer at3 and will be getting them in the next week. I liked the tires I had on mastercraft courser at2 but they really seemed to wear out quickly. I only put just under 30k on them and not much tread left. That's with rotating them every 6k. Also I was annoyed when a...
  13. C

    New tires

    I am looking to get new tires and was wondering what you guys are running since you deal with the same weather I do. The ones I was liking are the general grabber at2 and cooper discoverer at3. I don't do off roading but in the winter they don't seem to plow the roads when I head to work for...
  14. C

    Cleaning wheel well tips

    I am trying to clean the wheel well area where the plastic trim on the rear doors cover. Its caked with grit like it has never been cleaned and I have tried scrubbing it and it wont come off. Any tips?
  15. C

    What did you do to your jeep today?

    Today I washed it and installed the lift glass pad that I have been wanting for a long time. No more finger prints on the glass!!
  16. C

    plastic piece on rear lift glass

    Thanks. I couldn't think of what it was called.
  17. C

    plastic piece on rear lift glass

    I have seen it on some of the Liberty's I have seen driving around. I know it is to keep fingerprints off glass when closing it and I remember a thread on it but can't find it. Does anyone have the name or part #?
  18. C

    stupid tire pressure question

    Does the factory recomended tire pressure apply to both the 215/75/16 and the 235/70/16 or is a different pressure recomended for the 235?
  19. C

    wheel balancing

    I was wondering if a rim has a bunch of wheel balancing weight on it while the other 3 rims have very little; does that affect anything? I ask this because when I got my Mastercraft AT2s, after leaving the shop I noticed a vibration so I went back to have them rebalanced. They added a bunch of...
Top