Search results

  1. 0

    Rear Swing-Gate Flip-Glass Alignment

    Thanks for chiming in @Luke . Yeah, think I'm going to have to get out the mallet and try to encourage the hinges ... or take everything apart to gain a better understanding of the design.
  2. 0

    Rear Swing-Gate Flip-Glass Alignment

    Both @Luke . Drivers side is "slipped" down and touching the swing-gate and take a look at the ->||<- in both pictures. The glass is MUCH closer to the body pillar on the passenger side and MUCH further away from the body pillar on the driver side. So the glass needs both a horizontal and...
  3. 0

    Rear Swing-Gate Flip-Glass Alignment

    Popped the covers and loosened two hinge screws each hinge. Unable to move the hinges to a different position, as though there is no adjustment there ... unless something is corroded up and stuck under there.
  4. 0

    Rear Swing-Gate Flip-Glass Alignment

    @Jeremy-WI ... don't think so. Not at all worn or not worn enough to make the difference shown in the pictures. Reason I don't think a worn hinge is the problem is because with the flip glass unlatched, I can not move the glass around and see, find or feel play at either hinge pin. In other...
  5. 0

    Rear Swing-Gate Flip-Glass Alignment

    No help whatsoever. Read the OP. "Glass and gate open and close just fine, but the glass isn't centered." I could understand how adjusting the latch might be necessary if it shifted the glass to one side or the other, but it doesn't. I tried adjusting that latch (see the OP) and it had no...
  6. 0

    Rear Swing-Gate Flip-Glass Alignment

    The flip glass on my 03 KJ is not aligned / centered above the swing gate and I can't find any discussions or videos concerning this. Glass and gate open and close just fine, but the glass isn't centered. Wide gap at body pillar and contacting swing gate on driver's side. Little to no gap at...
  7. 0

    PCV Valve on Oil Filler Neck

    No tips, just a "I've been there too". Several years ago, the passenger side valve cover gasket all of the sudden just started leaking on my '03. Lots of smoke off the exhaust manifold. I took it to a Jeep dealer for repairs. They suggested that since one valve cover gasket started leaking ...
  8. 0

    Still Going Strong

    Sweet home Alabama. Where the skies are so blue. Started out life as a plain 'ol Jeep Liberty Sport when purchased new in May 2003. I've had the Jeep 20yrs. So long, she's part of the family and I long ago named her Ruby DeBadge 2" Daystar lift on 245 Michelin tires and Rubicon wheels Debadged...
  9. 0

    Cigar Lighter Conversion to Key On/Off

    Just what I was looking for. Thanks !
  10. 0

    What did you do to your jeep today?

    Warmed up today and I washed the Jeep. Just the paint. Didn't think the wheels and tires were too bad until I looked at this photo D'OH ! Bought new in '03. Jeep has never been garaged or waxed. Never been through a car wash with harsh chemicals either. Hand wash only and I can't remember the...
  11. 0

    42RLE Transmission : Engine rev / delay going into high gear

    While I can't explain how this hack changed the shift point and while no codes were being thrown before or now ... I've got to believe there is a failed component somewhere or another or something is somehow compromised. I just don't know what it might be. The slack I found in my Speed Control...
  12. 0

    42RLE Transmission : Engine rev / delay going into high gear

    HA !!! :D Went for another drive this morning, from a cold start of course. Definitely MUCH smoother shift and better shift points. Won't be shocked to find better gas mileage too. After topping the tank back off, preliminary indications are at least a 2mi per gallon increase in city driving...
  13. 0

    42RLE Transmission : Engine rev / delay going into high gear

    There was a day when I would have pulled the trigger on that idea right away, and it had crossed my mind, but my thinking goes like this and I quote ... "You know you've had this problem for a quite a while with engine revving and shift delay going into top gear. It was a consistent problem...
  14. 0

    Dash panel battery light

    O'Reilly. Pep Boys and possibly others can test the alternator (on or off the vehicle). Call your local parts house and see if they do. Make sure the "slight noise" isn't a belt slipping or something. Take a look at condition of wiring associated with the alternator and battery.
  15. 0

    42RLE Transmission : Engine rev / delay going into high gear

    Section 8P of the 2003 KJ Service Manual describes "Speed Control" in detail but no way ties it or that cable to the Transmission. I.just.don't.know. but glad shifting has improved for me.
  16. 0

    42RLE Transmission : Engine rev / delay going into high gear

    When I read "Speed Control" ... I think cruise control. Those two zip-ties have no affect whatsoever that I can tell on the cruise control. CC works fine. Maybe I'll get around to tracing that cable out. Dark outside ... and cold ... right now.
  17. 0

    42RLE Transmission : Engine rev / delay going into high gear

    Thanks !!! ... makes not sense really just by nomenclature and assumed functionality. But it sure did corrected a shift problem I've had for a while. It WAS engine revving and there was a shift delay going into high gear (or overdrive). Shifts smoothly now (taken it out 4 times, put 36miles on...
  18. 0

    42RLE Transmission : Engine rev / delay going into high gear

    ... and maybe that's a Speed Control Cable and not a Transmission Throttle Valve Cable ?!?!?! ... and if it is, how come that hack improved shifting, dare I say dramatically ?!?!?! Maybe I better check if cruise control still works D'OH !!! EDIT: Yep, cruise still works great. Wonder what this...
  19. 0

    42RLE Transmission : Engine rev / delay going into high gear

    03 Liberty with just under 55K miles ... yep, 55K Bought new in 03 and had fluid changed in transmission once, several years ago. In the last year or so, the transmission had gotten pretty bad about engine rev before going into high gear. I overfilled the transmission by a few ounces of fluid...
  20. 0

    Fire!

    He let the smoke out. You should never let the smoke out. Follow the burned wire. It should, might, maybe will tell what he did or didn't do. Weird that the original ground strap was burned in half before he replaced it along with all the other stuff. What did he think was going on with that? Or...

Latest posts

Members online

Top