Search results

Yeah, I just bypassed the leaking trans cooler and installed a Hayden unit, but would like to have installed a new condenser while it was out. My old one still works though.

Where did you find the condenser to fit a CRD? I ordered one from Rockauto which they said would fit, but it was too wide to tuck into the intercooler like it needs to.

Well, Gauge sweep goes up and down in 1/4 increments. New sending unit hooked up and moved float through a range of positions, no change. Voltage signal seems erratic. Anyone know what the voltage signal from the Front Control Module should be?

OK, went to the junk yard and scouted. Was able to poke around and see what was needed without worrying about destroying my trim. So for posterity, here is what I did. 1 - Open rear door and pull up on fastener on lower door seal. this is a small flat pad where the front and rear trim...

I recently had a similar problem. Only one good sensor. Got new tires and sensors and moved the good one to the spare position. The new sensors all registered after a drive as they should. Spare still read low. I moved the spare inside the cargo area and it was picked up in there. I then...

One of the things on my to-do list is to replace the dog-chewed rear seat belts. Looks like the interior panels need to come off for that. Any advice? Could only find KK stuff in my search.

Check your fans, that can make the high side spike. Your low side is not low enough to indicate a restriction.

Did your spare ever sync up? I moved the only working tpms to the spare and replaced all the others. Everything has self registered except the spare.

Cleaned the MAP Sensor in the CRD, zoom zoom! Also replaced rear glass lift struts.

Well today I put new wipers on. Yesterday I did a rear window regulator and polished the hood.

Need some pressure gauges to see what is going on. But, if it blows cold when jumped it is probably a bad switch. Easy and cheap to change.

Good tip on the gauge sweep. The gauge seems to respond accordingly so just need to run the tank down so I can drop it.

Hi, new to me 2005 Liberty CRD. This is my 4th Turbodiesel and joins my T1N sprinter and BMW 328D in the family fleet. Working through some normal KJ deferred maintenance and a google search led me to a thread here.