KJ 2006 3.7L Engine Temperature Slightly Low

[Morgan]

Hi, my Liberty 3.7L 2006 engine temperature gauge is always slightly lower than middle. Any suggestions on possible causes?

 

[Jeremy-WI]

Check the temp with a scanner, the gauge on the dash can't always be trusted

 

[KJowner]

Have you replaced the thermostat?

 

[Morgan]

Have you replaced the thermostat?

Nope. I thought that the thermostat will either be stuck open or close. Could the thermostat cause this? Picture attached.

 

[KJowner]

Just wondering if a lower temperature thermostat had been fitted.

 

[Morgan]

Just wondering if a lower temperature thermostat had been fitted.

Nope, still original

 

[DadOSix]

Hi, my Liberty 3.7L 2006 engine temperature gauge is always slightly lower than middle. Any suggestions on possible causes

I don’t see a problem there.

Those are not the most accurate gages. I have an IR temp gun that I use when I want to know for real. Has a lot of uses. Block temp. Rotor temp - when you are looking for a caliper that hangs up once in a while.

Why do you think it is low?

 

[Morgan]

I don’t see a problem there.

Those are not the most accurate gages. I have an IR temp gun that I use when I want to know for real. Has a lot of uses. Block temp. Rotor temp - when you are looking for a caliper that hangs up once in a while.

Why do you think it is low?

Thanks for the advise, I assumed the gauge is very accurate. I'll measure get an IR temp gun and also verify real temp with diagnostic tool.

 

[klc]

That’s where my gauge always sits. Normal operating temperature.

 

[Morgan]

That’s where my gauge always sits. Normal operating temperature.

Thanks, for letting me know.

 

[Gyro]

That’s where my gauge always sits. Normal operating temperature.

Mine Too.

 

[KJowner]

Mine sits in the center but I've got a CRD with the 88°C thermostat.