transfer case
-
B
NP231 Transfer Case & D30a Pinion Specs
Hello everyone: I am in need of some specs for the front output shaft on the KJ NP231 TCase & pinion on the Dana 30 A front diff. I need the following for D30a & NP231: - Output/pinion shaft diameter - Spline count - Hub diameter (seal diameter) - Through length (Through-hole/length of...- BlackBetty
- Thread
- d30a front differential np231 transfer case
- Replies: 1
- Forum: KJ General Discussion
-
NV/NP-231-J Help
Does anyone here know any good sites for transfer case parts? Im looking to rebuild my 231-J to see if it stops a drive train vibration due to a bad output shaft bearing. (case shows signs of a bad bearing. noise, vibrations and outer case is coated in oil) Just looking for a seal kit, bearing...- MarksmanAkula
- Thread
- 231j transfer case
- Replies: 10
- Forum: KJ General Discussion
-
Transfer Case Sticks after switched back to 2WD
Ive got a new to me 07' liberty with 183K miles on it. Recently went to test out the tcase and noticed it wouldn't disengage when switched back to 2WD. ended up turning off the jeep, switching tcase to 4hi then back to 2w, turned jeep back on and put it in reverse. Tcase went into 2wd. any ideas...- MarksmanAkula
- Thread
- transfer case
- Replies: 3
- Forum: KJ General Discussion
-
R
42RLE Transmission Replacement - '04 Jeep Liberty
42RLE Removal and Replacement [2004 Jeep Liberty Sport] --- Figured I would contribute finally after using all the helpful information on the forums over the last few years! I inherited a ’04 Jeep Liberty (Sport trim) by means of my wife back in 2014 with about 75k miles on it. I am a GM guy...
