BlackBetty
Member
Current Lift:
I am told that stock ride height is 19” in the front; therefore, a lift at 3.75” would be 22.75” ride height. However, I’m roughly 1.25” below that. I had my alignment done at the following settings: “set the camber on both sides as close to -0.4 degrees as possible and caster were ever it lands but the cross caster must be within 0.5 degrees. 2.5-3 degrees of caster is plenty.” I asked for a printout, but they said they set it at what I asked, and didn’t write or print out the actual settings.
My dilemma is that I believe I’ve followed the proper procedures, but it seems like I’m short of what other people are getting out of the same or similar lifts. Am I missing something here? I’d appreciate any feedback regarding my current situation.
- Front
- Spring: ARB OME 2927
- Strut: ARB OME 90009
- Top Spacer: 3/8” Spacer
- Clevis Lift: 4 on Driver’s side/3 on Passenger’s side (Conduit Nuts)
- Upgraded control arms to help with alignment & eliminate spring contact
- Height Measurements: FL = 21.5” & FR = 21.5”
- Rear
- Spring: RRO KJ7610 (Full Height 2.5-3” lift springs)
- Shock: Doetsch Tech Shocks
- Upgraded UCA & LCAs from IRO
- Height Measurements: RL = 21” & RR = 21.25”
I am told that stock ride height is 19” in the front; therefore, a lift at 3.75” would be 22.75” ride height. However, I’m roughly 1.25” below that. I had my alignment done at the following settings: “set the camber on both sides as close to -0.4 degrees as possible and caster were ever it lands but the cross caster must be within 0.5 degrees. 2.5-3 degrees of caster is plenty.” I asked for a printout, but they said they set it at what I asked, and didn’t write or print out the actual settings.
My dilemma is that I believe I’ve followed the proper procedures, but it seems like I’m short of what other people are getting out of the same or similar lifts. Am I missing something here? I’d appreciate any feedback regarding my current situation.