2011 KK Liberty - Cold Weather - not upshifting error TCM P0882

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

kiwi_outdoors

Member
Joined
Jun 16, 2022
Messages
59
Reaction score
32
It seems to be a problem only on the first drive of the day; i.e., after sitting overnight. But not always - currently about 50% of the days are affected. Jeep is in garage overnight - which is not cold.
 

Johnny O

Just hangin' out.
Joined
Apr 29, 2021
Messages
2,525
Reaction score
3,478
Location
Bellevue NE
What battery are you using? Have you had it tested? Liberties (pun intended) hate dirty power. How your contacts looking?

Since it is a low temperature issue...

Many "gremlin" issues on here corrected with an Odyssey AGM.
 

kiwi_outdoors

Member
Joined
Jun 16, 2022
Messages
59
Reaction score
32
Today I installed a brand new TIPM (from MAKS), preprogrammed for my VIN (took approx 30 minutes). The car runs fine.

Now we get to see what happens on successive days - if the electrical gremlins are still in the engine bay - or not!
 

kiwi_outdoors

Member
Joined
Jun 16, 2022
Messages
59
Reaction score
32
What battery are you using? Have you had it tested? Liberties (pun intended) hate dirty power. How your contacts looking?

Since it is a low temperature issue...

Many "gremlin" issues on here corrected with an Odyssey AGM.
Battery is about a year old. Voltage checks fine when monitored during starting and running.
 

lfhoward

Wheel. Repair. Repeat.
KJ Supporting Member
Joined
Dec 9, 2012
Messages
2,430
Reaction score
2,681
Location
Philadelphia, PA
Today I installed a brand new TIPM (from MAKS), preprogrammed for my VIN (took approx 30 minutes). The car runs fine.

Now we get to see what happens on successive days - if the electrical gremlins are still in the engine bay - or not!
I hope that solves it!
 

jessemcisaac66

New Member
Joined
Oct 23, 2023
Messages
1
Reaction score
0
Today I installed a brand new TIPM (from MAKS), preprogrammed for my VIN (took approx 30 minutes). The car runs fine.

Now we get to see what happens on successive days - if the electrical gremlins are still in the engine bay - or not!
I have been having the same issue with my transmission. I was going to suggest adding an external relay to the wire you were checking. That was the solution I came up with that didn't involve me spending almost $1000 on a tipm. So far it's working.
 
Top