A-Arm Installation, brake line in the way, help...

[tboneil24]

I can't figure out how to get the bolt out of the front A-Arm on the driver side. Theres a brakeline right in front of the bolt's exit way. It's completely loosened. I just cant pull it out because the brakeline is in the way. Any suggestions?

 

[ridenby]

Move the brake line??

 

[tboneil24]

Move the brake line??

Did that on the other side, this side I'd think I would have to bend it. I probably could take it off if it was just the nut but it has that lock lever on it. It's a 2005. I'll try to move it again but I didn't see that happening last night.

 

[recoil44]

Take the caliper off. Don't let it hang by the brake line.
I used a metal coat hanger. Just cut off the hook part and bend the wire as needed.

 

[tommudd]

Take the caliper off. Don't let it hang by the brake line.
I used a metal coat hanger. Just cut off the hook part and bend the wire as needed.

:happy175:
Hes talking about the rear bolt on the drivers side for the UCA,
to the OP
Unbolt the brake line, easy to do

 

[tboneil24]

:happy175:
Hes talking about the rear bolt on the drivers side for the UCA,
to the OP
Unbolt the brake line, easy to do

Right at that fitting going into the wheel-well? I'm going to have to bleed the system then right?

 

[recoil44]

:happy175:
Hes talking about the rear bolt on the drivers side for the UCA

whoops :icon_redface:

 

[tboneil24]

Nevermind, that was easy. Must have been tired last night. I removed the mounting nut inside the wheel well and pushed the brake line in and whoola. Very simple.