Flasher resistor mod

[Heavymetalduck]

I replaced all my turn signals and the first two LEDs caused hyperflash when I added anymore they just stayed on.

I didn't want to add resistors to every single led so I did this instead.

I'm followed some directions on another thread. I can't find it now but whoever made them your amazing.

You must be registered for see images attach

You must be registered for see images attach

I got lucky as the resistor just barely fits and I made sure nothing was touching.

Works well as I don't have hyperflash anymore.

The resistor I used

https://www.amazon.com/dp/B08LW33HT6?ref=ppx_pop_mob_ap_share

Edit:
The resistor used I used creates too much heat. I will reinstall a different resistor most likely 0.2 ohm.

 

[BlackBetty]

How was your experience with the 0.2 ohm resistor?

 

[lfhoward]

Has anyone figured out how to eliminate hyperflashing in a KK without having to add individual resistors to all 4 turn signals?

 

[Heavymetalduck]

How was your experience with the 0.2 ohm resistor?

I ended up using a 0.18ohm resistor and it no longer gets hot and doesn't even get warm.

 

[Heavymetalduck]

Has anyone figured out how to eliminate hyperflashing in a KK without having to add individual resistors to all 4 turn signals?

Do the kk liberty's have the same type flasher module?

 

[lfhoward]

Do the kk liberty's have the same type flasher module?

There is no flasher relay that can be swapped out in the KK because the flashers are part of the TIPM.

 

[klc]

You might need the bulbs with built-in resistors, then.

 

[Heavymetalduck]

Not sure why I can't edit my post but I replaced with the 1.8 ohm in the amazon link.

No longer heats up even after 10 mins.