I hadn't see a "HOW TO" on this yet, and I just did it in Jaine. For those of you who are tired of driving through parking lots from store to store, or just across your property and hearing the "BEEP....BEEEP...BEEEEP!!!!!"; this thread will show you how to disable it so all you have to worry about it the minuscule red light. This procedure takes less than five minutes to do in your driveway. This is my first "HOW TO", so bare with me.
1) Turn the ignition switch to the OFF position, and buckle the driver's seat belt.
2) Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running, but mine was) and wait for the Seat Belt Warning Light to turn off.
3) Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled.
4) Turn the ignition key to the OFF position. A single chime will sound to indicate that you have successfully completed the programming.
The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.
NOTE: Although the EWS (BeltAlert) has been deactivated, the Seat Belt Warning Light will continue to illuminate while the driver's seat belt remains unfastened.
Hope this was helpful. If you guys have any questions or concerns, just ask!:smokin:
1) Turn the ignition switch to the OFF position, and buckle the driver's seat belt.
2) Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running, but mine was) and wait for the Seat Belt Warning Light to turn off.
3) Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled.
4) Turn the ignition key to the OFF position. A single chime will sound to indicate that you have successfully completed the programming.
The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.
NOTE: Although the EWS (BeltAlert) has been deactivated, the Seat Belt Warning Light will continue to illuminate while the driver's seat belt remains unfastened.
Hope this was helpful. If you guys have any questions or concerns, just ask!:smokin: