Rear wiper?
- Thread starter Yoboloko
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
It's 11" I believe, I usually go to the dealer for it, but I think I have a Trico on it now and it's alright.
I have bought a Michelin 11" and converted it to work on my old unit https://www.amazon.com/ANCO-31-31-1...1-1&keywords=Jeep+liberty+rear+wiper+blade+11 but this one fits fine.
Laughter is the key to happiness
Laughter is the key to happiness
jharrisliberty
Full Access Member
You can also get them on amazon
Went to the dealer. No place around here has an 11" blade and I am fussy. I want it now and want it to fit right. They are not that expensive anyway.
Dave
ps.....I have no idea the brand...says MOPAR on the packaging.
Dave
ps.....I have no idea the brand...says MOPAR on the packaging.
Last edited:
How did you convert it? Do you need an adapter?
Does anyone use a 12" wiper blade?
Is it possible to put any blade on it, so long as there's an adapter for the J-Hook? I have the wiper from the dealer, but I'm wondering if I can put something more modern on it.
Is it possible to put any blade on it, so long as there's an adapter for the J-Hook? I have the wiper from the dealer, but I'm wondering if I can put something more modern on it.
Just bought Michelins that were on sale from Amazon and disassemble the blades then customized it to fit my old wiper assembly.
Laughter is the key to happiness
CzarKJ
Full Access Member
Link to the mopar one? Mine just fell the f*** off....
kage860
Full Access Member
My rear wiper has flung out a few 11" wipers in the past. Not sure if its the wipers or a bent j hook or a combination. I try to bend the j hook to get a better fit. But I've had good luck with a Duralast 11"from autozone and now an ANCO 11" from rockauto is doing well.
Charles Fry
New Member
(Not to brag) Mine was 11" , however, I can not for the life of me figure out how to get the new one on. The connector insert does not positively grab the arm/j hook. The two bits that came off the old one - I've spent about 3 hours attempting to fit them together and there is no possible combination of configurations that these pieces go together - even if they were there before.
