Recent content by Chispa
-
C
Where do the transmission cooling lines route on factory liberty CRD 2.8 diesel
I had a full rebuild done on a 2005 CRD engine. It seized after 750 miles, and he's rebuilding it again after finding that the exhaust valve in the third cylinder had blown apart and chewed everything up. What do you think, converted under warranty? He's been pretty quiet. It was a $15$ part he... -
C
If I can get this thing to put together I think I'll love it!
Thanks turblediesel !, McMaster car has alignment pins, but only straight or tapered. None that are mostly straight with a slight taper on the end, which is what the picture look like. And none with internal thread in one end to extract. . I found a place in France that has the part (see...- Chispa
- Post #3
- Forum: Introductions
-
C
If I can get this thing to put together I think I'll love it!
Hello, I have been working on a rebuild for my 2005 CRD for 4 months now. The folks at idparts.com have been awesome, but I have run into a snag looking for some new balance shaft assembly dowels that were damaged in the teardown. part # 5093899AA . Any help locating a set of 4 would be amazing!- Chispa
- Thread
- Replies: 10
- Forum: Introductions
Members online
No members online now.