Reverse

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Ericafisher01

New Member
Joined
Apr 16, 2023
Messages
1
Reaction score
0
2007 auto jeep liberty 3.7 does not back up when in reverse. All of the gears work fine but when in reverse it does not move when trying to accelerate. We tried changing the transmission fluid and filter and it did not get any better
 

blackhawk

Full Access Member
Joined
Apr 3, 2013
Messages
255
Reaction score
33
Location
Venezuela
I have this same problem but only when you want to back up in a slope. Try to use your 4x4 if you have it
 

jamesw

New Member
Joined
Sep 23, 2024
Messages
2
Reaction score
0
2007 auto jeep liberty 3.7 does not back up when in reverse. All of the gears work fine but when in reverse it does not move when trying to accelerate. We tried changing the transmission fluid and filter and it did not get any better
i have exactly that after new box fitted into 2.8crd. reverse should work in limp mode but i have not figured out how to put the car in limp mode yet any ideas?
 

KJowner

Full Access Member
Joined
Oct 20, 2022
Messages
1,434
Reaction score
818
Location
Uk
i have exactly that after new box fitted into 2.8crd. reverse should work in limp mode but i have not figured out how to put the car in limp mode yet any ideas?
Is it a new box or a second hand one?
Not sure if just unplugging it would do it, it would be purely in mechanical mode then.
 

Deb'nKJ

Full Access Member
Joined
Jun 3, 2022
Messages
633
Reaction score
535
Location
somewhere between London & Zunny Deb'n (England)
One of my XJ's developed that fault: it will only reverse in low, on the level & with the wheels straight ahead - but if I get out & lean against the B-pillar it will go faster than in neutral. Go figure. Time was when you could get an XJ for the cost of having a trans repaired - & I suspect KJ's are in that position now.

Different trans, very similar issue - so will be following this with interest, as have no idea what the problem is, much less the fix.
 

Jeremy-WI

Full Access Member
Joined
May 20, 2017
Messages
401
Reaction score
196
Location
Home
i have exactly that after new box fitted into 2.8crd. reverse should work in limp mode but i have not figured out how to put the car in limp mode yet any ideas?
Remove the fuse that powers the transmission
 

Latest posts

Members online

Top