Search results

  1. KingKJ

    Top end rebuild parts

    I need some help locating some quality parts to do my top end rebuild with, preferably in a kit and maybe some parts that aren't included in the kit that should be replaced on a motor that is 225k miles old. Luckily after scoping the pistons it appears the lower part of the engine won't need to...
  2. KingKJ

    Is this the end of Liberty?

    common past 100k... makes me glad mine lasted until 225k as far as I know(no previous paperwork for head gasket repair from previous owner)
  3. KingKJ

    Replacing Head Gaskets

    well good thing I'm doing that anyway, Just discovered the oil leak coming from there lol, still have head gasket issues, just now also have to do the gasket for front seal/timing cover/ something leaking oil in front of engine
  4. KingKJ

    Replacing Head Gaskets

    Honestly didn't know those are prescribed to come off lol, I was talking about all of the stuff that's located on top of the engine that us visibly in the way.
  5. KingKJ

    Replacing Head Gaskets

    We just replaced the spark plugs and the engine is also throwing misfires still, haven't checked compression, the valve guides and stem seals will be looked at during the teardown process. I'm hoping the pistons aren't too bad, but I'm also a bit worried just because of age and the fact I've...
  6. KingKJ

    Replacing Head Gaskets

    Alright, I'll have to see once I actually get it off how bad the gasket is, but I don't think it's all the way dead just because I'm not mixing coolant yet so I'm assuming the gasket hasn't completely failed, but it is starting to fail. Also I plan on doing both sides just because they are both...
  7. KingKJ

    Replacing Head Gaskets

    So pretty much I discovered this last week that my Liberty is burning oil at a quick rate and it is most likely a head gasket issue. I had to drill holes above the cats after a vacuum line failed and I've been getting small amounts of oil leaking from the holes I drilled as well as when starting...
  8. KingKJ

    What did you do to your jeep today?

    Lucky, I'm a little disappointed I've yet to have a chance to really just slide around in my jeep the only real snow I've dealt with has been going down a mountain pass, not a place to try to drift lol.
  9. KingKJ

    Breather lines

    I'm planning on 3 inch lift and don't plan on deep water, but better safe than sorry
  10. KingKJ

    What did you do to your jeep today?

    It's running fine after we replaced that, we did have to replace spark plugs and drill holes in cats to get it to run fine but now it's running fine
  11. KingKJ

    Breather lines

    Does anyone know how many breather lines the first gen liberty's have and where they are located(differentials, transmission, etc.) I want to raise them higher when I do my lift kit just so I don't have to worry about it later. Also what would the process be to extend them?
  12. KingKJ

    What did you do to your jeep today?

    honestly just a guess but judging by the fact it clogged my cats and that my new exhaust got coated in like an inch of soot, I'd guess it was running rich, it could've been low, but it was just my guess based on how much junk got shoved out the exhaust.
  13. KingKJ

    What did you do to your jeep today?

    there's a T on the passenger side where the vacuum line goes to the airbox and it splits and the line goes somewhere to the back of the block, the old plastic was old and just snapped while I was driving
  14. KingKJ

    What did you do to your jeep today?

    Nvm just had a vaccum leak and the engine ran rich so it ruined my spark plugs and completely clogged up the cats to the point in order to get it to drive I had to drill holes before the cats, so now it's just obnoxiously loud :(
  15. KingKJ

    What did you do to your jeep today?

    Installed my MBRP exhaust today! (clip of how it sounds)
  16. KingKJ

    lockers

    yeah, theoretically the front end would be locked the least as well as locked/unlocked at a full stop, I'm just making sure it won't damage anything while locked.
  17. KingKJ

    lockers

    https://store.arbusa.com/air-locker-differential-dana-30-27-spl-3-73-up-rd100/ I just found this locker for sale at arb for jeep liberty, this should be something that works for the liberty, but is it fine to have a fully locking differential for the front differential? Or is it something I...
  18. KingKJ

    lockers

    would anything the fits the dana 30 fit even if I had a different gear ratio in there? I am planning on finding some 4.10 gears for the front
  19. KingKJ

    lockers

    I'm looking for lockers for front and rear for my liberty and am wondering where I can buy them and will they be compatible if I regear to 4.10 Does anyone have some links to where I can buy them or some estimated costs? I'd like to keep it as budget friendly as possible but also don't want to...
  20. KingKJ

    Do I have the parts correct for my lift kit and what is the difference between front and rear height

    Ok, I don't think rust is a huge worry, suspension tends to do that because it's so exposed

Random media

2006 jeep Liberty Renegade kj
35E1E87F-1D7F-46F9-9EA2-C3B9AF581766.jpeg
img056
new jeep
jeep2
04 lib rene 002
0627161940
right brake light socket
Flex after lift

Latest posts

Members online

Total: 233 (members: 6, guests: 227)
Top