Search results
-
2009 KK Jeep scalloped driver front tire
Get an alignment too. Gyro- Gyro
- Post #2
- Forum: KK General Discussion
-
How to choose the correct O2 sensors
Jeep KJ likes copper core NGK ZFR 6F-11G gap set at .040. Jeeps have never been famous for good gas milage.:D Gyro- Gyro
- Post #4
- Forum: KJ General Discussion
-
How to choose the correct O2 sensors
That is the correct sensor. It will fit all positions. Have someone with a code reader check for codes, to see which sensor is faulty,no need to replace all sensors. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Help needed badly.
Is the cable itself broke or just the end bushing where it connects to the TC lever. Often times it's just the bushing that fails. Gyro- Gyro
- Post #14
- Forum: KJ General Discussion
-
Where would I find some of these nerf bar mounting bolts?
A junk yard might be the best bet. Those are used to hold on the front tow hooks on kj's. Yes they are known as M bolts. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Car Handling Issues at High Speeds: Rear-End Swerves and Knocking Sound – Seeking Advice!
Likely the rear lower control arms bushings. Call your local Jeep dealer with your VIN# and see if the recall on the lower control arms has been done. Could be a free repair/solution. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
What part is this ?
It normally slides over a bolt on the top strut mount,you can zip tie it next the battery. Gyro- Gyro
- Post #3
- Forum: KJ General Discussion
-
ARB Bumper Discontinued
Ouipack is where I got my bumper. The last one in stock and for less than a grand shipped to the east coast.Years ago. Tdot Performance in Toronto is now arb dealer.- Gyro
- Post #9
- Forum: KJ General Discussion
-
MOAB's wheel year for 2007
You can go as many as 3 conduit nuts(3/8inch),any more it pushes the shock too far out of the clevis clamp. They slide over the round part of the shock that slides into the clevis fork. Gyro- Gyro
- Post #8
- Forum: Tires / Wheels
-
MOAB's wheel year for 2007
The 927 is fine for the ARB bumper alone,ARB bumper and winch should use the 790 or CRD. Just the 3/8 spacer on top and 1/4 on the bottom,for roughly an inch of extra lift. About 3.5in of total lift. Gyro- Gyro
- Post #6
- Forum: Tires / Wheels
-
MOAB's wheel year for 2007
Springs OME 927 front ,OME 948 rear. TP = Top Plate for front shock.Between shock mount and body.for extra lift 2 ring clevis=1/8in spacers x2 between clevis and bottom of shock. for extra lift.3 max. Gyro- Gyro
- Post #4
- Forum: Tires / Wheels
-
AC refrigerant leaking from black tube after being charged
That is the AC condensation drip hose. It is normal for it to drip during AC use.It is water not refrigerant. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
MOAB's wheel year for 2007
I have 06 TJ moabs on my 07. All KJ years have 5x4.5 bolt pattern. Gyro- Gyro
- Post #2
- Forum: Tires / Wheels
-
'03 KJ, NP242 and 45rfe, no forward power except in 4lo.
Your trouble seems to be with the transmission not the TC. I would get that checked first. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Bilstein Strut-OME Spring Q's and Deeke UCA Q's
I would say yes to the brake extensions,better safe than sorry. I did on my 07. Here the link to the how to- http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=45640&p=589570#p589570 Gyro- Gyro
- Post #3
- Forum: Lift Kit Discussion
-
‘07 Liberty 4WD shifter dash light
If you are sure it is shifting correctly, it is likely the TC position sensor. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
RPMs intermittently stuck when lightly applying gas, slow response over 50 mph
Your idle rpm,s (546) are not far from 600(proper). Fuel pressure should be 58+/- 5 your,s shows 50.should be fine. Have you checked the spark plugs? How many miles on them? What gap? Gyro- Gyro
- Post #24
- Forum: KJ General Discussion
-
AC Compressor oil fill necessary?
Remove serpentine belt from pulley, check the shaft for play, in and out, up and down and check clutch for play on the shaft. If it shaking bad,may want to replace the belt also. Gyro- Gyro
- Post #4
- Forum: KJ General Discussion
-
AC Compressor oil fill necessary?
If it's just the clutch bearing, there are rebuild kits and it's an easy fix. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
NOR/AM has some new body panels for 02-07 liberty
NOR/AM has some new body panels for 02-07 liberty. A new rocker panel with partial pillars. Dog leg section for rear door. Rear upper wheel arch. Can be found here https://www.noramstore.ca/c-1423999-chrysler-amc-jeep-jeep-liberty-2002-2007.html Can't seem to post the USA link. They are in and...- Gyro
- Thread
- Replies: 2
- Forum: KJ General Discussion
