H&R Spring Review

[JustSumDad]

The spring is physically longer with additional coils though, so without a longer bump stop it could bottom out, as the H&R lift is quite small I don't know if this would be a problem, the OP on this post had issues, but Erskine didn't so difficult to call, personally I'd go with Tom's rule of inch of lift = inch of extra bump stop for peace of mind.

ok, I figure the rear adding a hocky puck to the bottom of each side is minimal. Not sure how they secure, but I will work that out when I see the setup first hand...
how are front bump stops done?

 

[derekj]

This is what the extended front bump stops look like - you can get these ones on eBay or if you call Terraflex they apparently still sell theirs but just don't have them online. they just snap into a cup on the body above the upper control arm.

You must be registered for see images attach

 

[CheddarGau]

This is what the extended front bump stops look like - you can get these ones on eBay or if you call Terraflex they apparently still sell theirs but just don't have them online. they just snap into a cup on the body above the upper control arm.

You must be registered for see images attach

I have tried several times, and I still can't get mine into their home. The day I get them in ill celebrate. All the difficult things I do on cars and can't get these in

A great member from here sent them up to me from their place.

 

[JustSumDad]

This is what the extended front bump stops look like - you can get these ones on eBay or if you call Terraflex they apparently still sell theirs but just don't have them online. they just snap into a cup on the body above the upper control arm.

You must be registered for see images attach

They appear to be for 2" lift. do you just cut them down to match a lower lift?

 

[Gyro]

I have tried several times, and I still can't get mine into their home. The day I get them in ill celebrate. All the difficult things I do on cars and can't get these in

A great member from here sent them up to me from their place.

A 2x4 on edge using the tire as a fulcrum seems to work for most.