Project to divert KK coil to KJ
- Thread starter ikuo78
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
surely.
I also end up buying low-quality products without checking.
Manufacturers with IR on their HP are generally fine.
I replaced the serpentine belt because I smelled rubber from the engine compartment.
The belt had many cracks.
It was a different part number than the service manual.
For the 2003 model, the service manual lists only one belt option.
Maybe someone replaced it?
I don't know the correct length, but the belt is 2225mm, and the tensioner is working and working properly at the moment.
The belt had many cracks.
It was a different part number than the service manual.
For the 2003 model, the service manual lists only one belt option.
Maybe someone replaced it?
I don't know the correct length, but the belt is 2225mm, and the tensioner is working and working properly at the moment.
You must be registered for see images attach
You must be registered for see images attach
Luke
Interloper
Cheap insurance… Good call!
I also replaced the saddle on my child's bicycle yesterday, but that was more expensive.
When I replaced the serpentine belt, I noticed some play in the water pump, so I replaced it without ignoring it.
I was unsure about the belt length, so I drew a line at the belt tensioner's limit position (24mm before the stopper).
In the end, the belt was too long, so I replaced it with a 2200mm one.
before belting
After putting on the belt
I was unsure about the belt length, so I drew a line at the belt tensioner's limit position (24mm before the stopper).
In the end, the belt was too long, so I replaced it with a 2200mm one.
You must be registered for see images attach
before belting
You must be registered for see images attach
After putting on the belt
