Search results
-
-
Need your advice on front suspension issue
I used ratchet straps to pull it into place. The fork legs have a lip on the inside top to help align and hold in place for bolt to be inserted. Gyro- Gyro
- Post #3
- Forum: Lift Kit Discussion
-
05 CRD: Is there a dimmer for the dash lights? Illumination for new radio head unit flickering
It should be on the turn signal/ head light stalk.- Gyro
- Post #2
- Forum: Electronics
-
What did you do to your jeep today?
New radiator and serpentine belt for the 06 Renegade.- Gyro
- Post #23,703
- Forum: KJ General Discussion
-
What did you do to your jeep today?
Replaced lbj x2,tre x2,front brakelines x2,uca x2(from my 07 w/60k kms on them)and an alignment on the 06 Renegade. Gyro- Gyro
- Post #23,365
- Forum: KJ General Discussion
-
Transmission service manual for 42RLE (non-VLP)
Section 21 page 55 is not what you are looking for? Gyro- Gyro
- Post #4
- Forum: KJ General Discussion
-
Transmission service manual for 42RLE (non-VLP)
Go here http://www.colorado4wheel.com/manuals/Jeep/KJ/ D/L the fsm and parts fiche for your year. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Intermediate Front shaft
The right front axle is a two piece set up,outer shaft has the cv's and the inner is a straight shaft. https://www.morris4x4center.com/axle-shaft-front-inner-dana-30-186-lh-rh-5066057ab.html Gyro- Gyro
- Post #6
- Forum: KJ General Discussion
-
Left windshield pillar socket - what’s it for?
It might also be for the roof mounted light bar.(Renegade) Gyro- Gyro
- Post #4
- Forum: KJ General Discussion
-
8.25 DTT Carrier Install Specs –Ring Bolts, Preload, Backlash, Bearing Caps
Go here and D/L the 03 service manual http://www.colorado4wheel.com/manuals/Jeep/KJ/ Section 3 should have everything you need. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Replacement rockers
The 2 pieces each side plastic covers are held on by plastic clips and a plastic rivet on front and rear wheel well. Chances are the bottom of the wheel wells and the inner rocker are rotted too. Might be easier to get the steel rockers welded on. There are two types of replacements slip ons and...- Gyro
- Post #2
- Forum: KJ General Discussion
-
What is this for? Orphaned electrical socket in engine bay
On my 06 3.7 it goes to the CC servo. Gyro- Gyro
- Post #4
- Forum: KJ General Discussion
-
Why are we still here? The legacy of the Jeep Liberty
Coming up on 10 years of ownership of my 2 Liberty's. 07 in March,06 in August. Would not trade them for the world. Gyro- Gyro
- Post #57
- Forum: KJ General Discussion
-
What did you do to your jeep today?
06 passed another inspection but for the tires.10 year old michelin,s are age cracked. Michelin does make the ltx in 235 70 16 anymore, so ordered some Ko2,s. Gyro- Gyro
- Post #22,134
- Forum: KJ General Discussion
-
What did you do to your jeep today?
-26c here this morning,had to gently pry open drivers door to get in the 07,then had to pry open the hood to boost to get it running. Then had to work it in 4wd to get out of the ice it was frozen in. Then we lost power, and had to get the generator out and running,then off to grocery store. Got...- Gyro
- Post #22,060
- Forum: KJ General Discussion
-
What did you do to your jeep today?
Had to replace both wheel speed sensors on the left side of the 07. Also think I found the clunk from the rear, looks like the body side of the boomerang are making contact with the mount when flexing. There are divots on boomerang from contact.Going to die grind a little out and see if that...- Gyro
- Post #21,851
- Forum: KJ General Discussion
-
What did you do to your jeep today?
New blower motor resistor on the 06. Had to go with the stock type, local Napa is out of the sebring type and can't get them. Gyro- Gyro
- Post #21,766
- Forum: KJ General Discussion
-
Jeep hints at the Obese Second Cousin of the Liberty
That's over 93,000 Loonies. I'm going to need a bigger coin jar.- Gyro
- Post #8
- Forum: Other Jeep Models
-
-
What did you do to your jeep today?
Did some body work on the doglegs at the rear doors on the 07 and touched up the underside with fluid film.- Gyro
- Post #21,414
- Forum: KJ General Discussion
