Gear Pattern, Is it Good?

[tyates007]

I am finally getting around to installing my Eaton TT and 4.10 gears. I am getting very close on the pattern but would love someone to look at it for a second opinion, or third. I think I need to shim the pinion a little more to bring it closer to the ring gear. Backlash is at .007.

You must be registered for see images attach

You must be registered for see images attach

 

[tyates007]

This morning I pulled it all apart and added .010 to the shim stack on the pinion. First set of pictures is with Backlash at a tight .006 and second pattern is with .008

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[JeepJeepster]

Something I recently learned, its just as important to look at the pinion gear itself. The pattern should be near the center of the teeth.

Im no expert, but it almost looks like it was too shallow then you went a bit too deep.

 

[tyates007]

Something I recently learned, its just as important to look at the pinion gear itself. The pattern should be near the center of the teeth.

Im no expert, but it almost looks like it was too shallow then you went a bit too deep.

Thank you for checking it out for me. I thought the same thing, to shallow and then to deep. Here is where I landed with the last adjustment. I think I am pretty close now

You must be registered for see images attach

You must be registered for see images attach

 

[CheddarGau]

Here is patterns from service info. This is the front. There is a lot more info above in terms of setting it up, but this will help you with your patterns.

You must be registered for see images attach

 

[CheddarGau]

Rear

You must be registered for see images attach

You must be registered for see images attach