What did you do to your jeep today?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

cplchris

Full Access Member
Joined
Feb 10, 2010
Messages
804
Reaction score
10
Location
Albany, NY
don't forget the weep hole as well.
if it starts weeping, i believe that's a tell tale sign that it's time to replace the WP.

yea i can't tell if it is coming from the weep hole or the gasket though. i replaced the water pump a couple of years ago so i don't think that would be the issue but i'm keeping my eye on it. i may just pull up the receipt for the pump and see if it is still under warranty.
 

drowssap

Full Access Member
Joined
Nov 26, 2016
Messages
54
Reaction score
0
Location
Denver
yea i can't tell if it is coming from the weep hole or the gasket though. i replaced the water pump a couple of years ago so i don't think that would be the issue but i'm keeping my eye on it. i may just pull up the receipt for the pump and see if it is still under warranty.

I can show you plenty of defective water pumps that were brand new right out of the box! Very unlikely that just the gasket is leaking unless the pump was not installed correctly
 

sota

Full Access Member
Joined
Apr 6, 2011
Messages
2,394
Reaction score
1,247
Location
NJ
feel like i've been a bad owner.
left it outside to get wet. pulled it in the garage and started hitting the hood with the clay bar. sounds like i'm running 60grit over the hood. I think I'm going to totally trash a brand new bar just getting a first cleanup pass done.
 

krisP

Full Access Member
Joined
Nov 8, 2015
Messages
483
Reaction score
0
Location
NY/PA
put the new bilsteins on the back. WOW what a difference, those ironmans were complete junk straight out of the box
 

sota

Full Access Member
Joined
Apr 6, 2011
Messages
2,394
Reaction score
1,247
Location
NJ
finished claying the jeep in the rain today. Holy hell some of those panels were DISGUSTING. I'll wait until the next rain storm, then clay it again. Should be ready for wax at that point.
 

GunnerSchenck

Full Access Member
Joined
Dec 24, 2014
Messages
850
Reaction score
8
Location
Sugar Grove, Warren County, Pennsylvania
You shouldn't be anywhere near your vehicle when you've been drinking, unless it's to climb in the passenger side.

Seemed better than the tent outside when I went camping last time... I was wrong. Too tall to lay down in the back comfortably, plus the fact the seats don't go flat is hella annoying..
Notice I said sleep on my seat drunk, not drive. I do not condone drinking and driving by any means.
Besides I left my keys in the tent (to keep myself from touching the ignition with them as this is illegal even if the vehicle is not started)..
And to get out of my jeep at that point to make it to the tent.. would've taken the jaws of life to pry me off the rock of a seat that I had become one with
 

wheeee32

Full Access Member
Joined
Feb 27, 2009
Messages
1,358
Reaction score
26
Location
Not the mountains.
finished claying the jeep in the rain today. Holy hell some of those panels were DISGUSTING. I'll wait until the next rain storm, then clay it again. Should be ready for wax at that point.

In the rain?? You should be using a good detailing spray with that clay bar. Also thoroughly wash the vehicle before you put a clay bar to it.
 

sota

Full Access Member
Joined
Apr 6, 2011
Messages
2,394
Reaction score
1,247
Location
NJ
In the rain?? You should be using a good detailing spray with that clay bar. Also thoroughly wash the vehicle before you put a clay bar to it.

It's New Jersey; we have "special" rain.
 

GunnerSchenck

Full Access Member
Joined
Dec 24, 2014
Messages
850
Reaction score
8
Location
Sugar Grove, Warren County, Pennsylvania
It's still acid rain though lol..
Ever seen those white cars that look yellowed as you walk around them? Clearcoat degradation from acid rain..
Also I've seem plenty of acid rain spots on cars that rolled into the shop, and believe me.. they're beyond annoying to get out.
You have to neutralize the stain, clean the car.. scuff and buff like there's no tomorrow...
And they'll still be there lol
 

sota

Full Access Member
Joined
Apr 6, 2011
Messages
2,394
Reaction score
1,247
Location
NJ
it's a jeep. it' supposed to be tough. a little NJ rainfall won't hurt it. :D
 

dee004

New Member
Joined
Feb 8, 2012
Messages
7
Reaction score
0
Location
Ontario
Put her winter shoes on. Gotta make sure she's ready to get me to the lake for Ice fishing.
 

Myke

Full Access Member
Joined
Nov 13, 2016
Messages
563
Reaction score
5
Location
USA
Mounted a 42" curved led light bar after work
 

drowssap

Full Access Member
Joined
Nov 26, 2016
Messages
54
Reaction score
0
Location
Denver
Got started on replacing the clutch. Don't really want to but this is an easy vehicle to work on. Started on the EVIC install that I got really lucky finding and also added steering audio controls. I did it the easy/hard way though. I didn't trust myself to cut the plastic well enough so I swapped the backs but my clock spring doesn't have the terminals so I will be swapping that tomorrow!
 

sparky123321

Full Access Member
Joined
Oct 22, 2016
Messages
228
Reaction score
2
Location
New Hampshire
Hoping to start the install of my H&R springs/lift today along with replacing the BJ and TRE dust boots with Energy Suspension polyurethane boots. I will inspect and replace any worn BJ or TRE if needed. Ordered Moog Problem Solver parts ahead of time, but will return if not needed. I like to plan for the worst so expecting the Libby to be down for a couple days.
 

Latest posts

Members online

Top